ESOTERIC AB-T1KD1 Mj Series Inverters Archivos Owner’s Manual

ESOTERIC AB-T1KD1 Mj Series Inverters Archivos

Thank you for purchasing this ESOTERIC product.
Read this manual carefully to get the best performance from this product. After reading it, keep it in a safe place with the warranty card for future reference.

Before use

This product is an arm base kit for mounting a tonearm on a Grandioso T1.

Supported tonearms

• IKEDA
• IT-345 (9-inch)
• IT-407 (12-inch)

ATTENTION
IT-345 tonearms cannot be installed on the front left of the Grandioso T1.

Package contents

Included accessories

• Hex wrench × 1
• Owner’s manual (this document) × 1

Please contact the store where you purchased this product if any of these package contents or accessories are missing or have been damaged during transportation.

Installation procedures

If the motor unit has been installed, follow the procedures beginning on page 19 of the Grandioso T1 Owner’s Manual to remove it before installing the arm base kit.

1. Remove the top of the leg from the base unit.
   At the location where you want to install the tonearm, turn the top of the leg counterclockwise and remove it.

   • Tonearms can be installed in three locations: the back right, the back left and the front left.
     ATTENTION IT-345 tonearms cannot be installed on the front left.

2. Install the arm base post on the base unit.
   Referring to “Arm base post installation diagram” on page 7, attach the arm base post with the attachment screws.

3. Install the arm base.
   Align a positioning indentation on the underside of the arm base with the pin on the arm base post when installing it. The two different positioning indentations are for IT-345 and IT-407 tonearms. Select the indentation to use according to the tonearm being installed.
   When placed correctly, the tops of the arm base and the arm base post should be almost the same height. If there is a large height difference between the arm base and the arm base post, the positioning indentation and the pin might not be aligned. Try installing the arm base again.

4. Fix the arm base in place.
   Tighten the arm base attachment thumbscrew to fix it in place.

   • After fixing it in place, confirm that there is no looseness in the arm base.

5. Attach the tonearm to the arm base.
   Refer to the tonearm owner’s manual for installation procedures.
   When not using a VTA elevator, insert the adapter included with this kit into the hole in the arm base before installing the tonearm.

6. Install the motor unit.
   Following the instructions starting with procedure 10 on page 16 of the Grandioso T1 Owner’s Manual, install the motor unit.

Arm base post installation diagram

Arm base installation diagrams

IT-345 installation

IT-407 installation

Model for Europe
This product complies with the European Directives request, and the other Commission Regulations.

Model for UK
This product complies with the applicable UK regulations.

Disposal

For European Customers
Disposal of electrical and electronic equipment and batteries and/or accumulators

• a) All electrical/electronic equipment and waste batteries/accumulators should be disposed of separately from the municipal waste stream via collection facilities designated by the government or local authorities.
• b) By disposing of electrical/electronic equipment and waste batteries/accumulators correctly, you will help save valuable resources and prevent any potential negative effects on human health and the environment.
• c) Improper disposal of waste electrical/electronic equipment and batteries/accumulators can have serious effects on the environment and human health because of the presence of hazardous substances in the equipment.
• d) The Waste Electrical and Electronic Equipment (WEEE) symbols, which show wheeled bins that have been crossed out, indicate that electrical/ electronic equipment and batteries/ accumulators must be collected and disposed of separately from household waste. If a battery or accumulator contains more than the specified values of lead (Pb), mercury (Hg), and/or cadmium (Cd) as defined in the Battery Directive (2006/66/EC, 2013/56/EU), then the chemical symbols for those elements will be indicated beneath the WEEE symbol.
• e) Return and collection systems are available to end users. For more detailed information about the disposal of old electrical/electronic equipment and waste batteries/accumulators, please contact your city office, waste disposal service or the shop where you purchased the equipment

ESOTERIC is a trademark of TEAC CORPORATION, registered in the U.S. and other countries.
Other company names, product names and logos in this document are the trademarks or registered trademarks of their respective owners.

ESOTERIC COMPANY 1-47 Ochiai, Tama-shi, Tokyo 206-8530, Japan Phone: +81-42-356-9156

This product has a serial number located on the rear panel. Please write it here and retain this for your records.
Model name: AB-T1KD1
Serial number

ESOTERIC is a trademark of TEAC CORPORATION, registered in the U.S. and other countries. Other company names, product names and logos in this document are the trademarks or registered trademarks of their respective owners.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>