MARTEC TLCD34510WD Tricolour LED Downlight Instructions
- June 12, 2024
- martec
Table of Contents
MARTEC TLCD34510WD Tricolour LED Downlight
Product Information
- Product Name: Class II 10W Tricolour LED Downlight
- Model: TLCD34510WD and TLCD34510MD
- Dimensions: 90mm (outer diameter), 100mm (cut-out diameter), 100mm (depth)
- Compatibility: IC-4 and IC-F rated for use in insulated ceilings
- Installation Method: Abutted & Covered
- LED Driver: Included
- Color Temperature Options: Warm White (3000K), Neutral White (4000K), Cool White (5000K)
Product Usage Instructions
- Ensure the power is switched off before installation.
- Insert the plug of the LED driver into a compatible socket.
- Find the appropriate location in the ceiling and make sure there is a clearance of at least 25mm around the downlight.
- Use the provided spring mechanism to install the LED downlights follows:
- Push the spring up towards the downlight.
- Place the LED downlight into the ceiling cut-out.
- Release the spring, ensuring it engages securely with the ceiling.
- Verify that the LED downlight is firmly in place and properly aligned.
- Switch on the power and enjoy the illumination provided by the LED downlight.
Class II 10W Tricolour LED Downlight Model: TLCD34510WD and TLCD34510MD
INSTALLATION
- This unit must be installed and wired by a qualified electrical contractor
- Ensure power is off at mains before wiring and installation
- For maximum number per circuit breaker, use the recommended quantities as for a standard mains 50W lamp (or 100W R80)
- Ensure that the area that the unit is to be fitted has a minimum height clearance of 20mm
- Cut a suitable hole in the ceiling for each unit ensuring no positions are under joists, cables, pipes etc
- Terminate cables at primary side of driver ensuring cable clamp is in place
- Feed springs through the ceiling hole slowly releasing the unit up to the ceiling. The springs will hold the fitting in place
- Fixture control gear/driver must be mounted above any insulation covering the luminaire
- For indoor use Ta = 25°C
INSTRUCTIONS
Select the colour preference by sliding the dip switch on rear of down light.
(3000K, 4000K, 5000K)
Connect fitting to the mains power via power plug.
DIMENSION
INSULATION
Thermal insulation clearance class IC-4 covered; meaning that theClass LED downlight can be covered entirely by insulation abutting or is within 100mm horizontally of the luminaire. And must meetthe following requirements: Be of a type that can maintain its dimensions and structural integrity when exposed to a maximum surface temperature the class of the luminaire, being 90°C; Be of a type that can withstand a 30 second needle flame test carried out in accordance with AS/NZS 60598.2.2 with a flame applied to all surfaces of the sample insulation types which should be used with this fitting are glass wool (pink batts) & polyester.
DIMENSION (FOR DRIVER ) CLEARANCE
- SC_ Side clearance to thermal insulation and building element. 25mm
- HC – Height clearance to thermal insulation and building element. 20mm
IMPORTANT NOTE
- This fixture must not be installed with loose fill insulation (as defined in NZS 4246) such as macerated paper and wool.
- Fixture control gear/driver must be mounted above any insulation covering the fixture.
Aust/NZ Approval No. GMA-509639
www.martecaustralia.com.au
02 8778 7500
sales@martecltd.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>