DIRECT COLORS DC-CCB-4OZ ProClean Neutralizer User Guide
- June 13, 2024
- Direct Colors
Table of Contents
DIRECT COLORS DC-CCB-4OZ ProClean Neutralizer
Product Information
The ProClean NeutralizerTM is a cleaning solution designed for concrete surfaces. It effectively removes residue and prepares the surface for further treatment such as staining or sealing. The solution comes in concentrate form and is available in two sizes: 1gallon and 5 gallons.
Product Usage Instructions
- Calculate Solution Amount: Determine the size of your project in square feet. Keep in mind that 1 gallon of ProClean NeutralizerTM covers approximately 200 square feet.
- Select Concentrate Size: Choose the appropriate concentrate size based on the amount of solution you need to make (1 or 5 gallons).
TOOLS FOR THE JOB
PROCLEAN NEUTRALIZER™ HOW-TO GUIDE
STEP 1: CALCULATE SOLUTION AMOUNT
- Determine project size in square feet.
- Remember, 1 gallon covers approximately 200 square feet
STEP 2: SELECT CONCENTRATE SIZE
- ProClean Neutralizer™ is available for making 1 or 5 gallons of solution.
STEP 3: MIX SOLUTION
- For 1 gallon: Mix 4 ounces of ProClean Neutralizer™ concentrate with 1 gallon of water.
- For 5 gallons: Mix 1 quart of ProClean Neutralizer™concentrate with 5 gallons of water.
STEP 4: PREPARE SPRAYER/CONTAINER
- Remove filters if using a sprayer.
- Pour concentrate into sprayer or mixing container.
- Add corresponding water amount.
STEP 5: APPLY THE PROCLEAN NEUTRALIZER™ SOLUTION
- Wear spiked shoes to avoid leaving shoe prints on the floor.
- Scrub the concrete surface using a scrub brush or a lowspeed floor buffer with a brush attachment.
- Remove the residue with a wet-dry vacuum (a cottonmop can be used, but it is less effective).
CAUTION : ProClean Neutralizer™ may be harmful if swallowed or ingested. Contact with skin can cause mild irritation. Avoid contact with eyes.
STEP 6: RINSE AND DRY THE SURFACE
- Rinse the surface thoroughly: Use plenty of water to wash away all residue from the surface. Ensure that no residue remains on the surface, as it is crucial for the success of the following steps.
- Double-check for any remaining residue: IMPORTANT:
- Take extra care to remove all traces of residue from the surface. Applying a stain or sealer over any leftover residue will lead to poor adhesion, compromising the final result.
- Let the surface dry completely: Wait for at least 8 hours before applying a sealer to ensure the surface is entirely dry.
- This waiting period is essential for the sealer to adhere correctly.
Disclaimer : Direct Colors does not warranty or guarantee results
(outcomes). Concrete variations or improper application may cause unintended
results. Test product on an inconspicuous or small area and allow to fully
cure to ensure compatibility and desired result.
DirectColors.com
cs@directcolors.com
405-275-6657
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>