Puig Protector Motor Pro 2.0 for SUZUKI GSX-R1000 ’17-’22 Instruction Manual
- June 13, 2024
- Puig
Table of Contents
Puig Protector Motor Pro 2.0 for SUZUKI GSX-R1000 ’17-’22
INSTRUCTIONS TO ASSEMBLE
Remove the fasteners that subject the chassis to the engine. Mount the protectors on each own side as the figure below shows. Tight the set, and place the caps. All the screws replaced, should be tightened to the torque specified in the oem maintenance manual for your motorcycle. if no torque specifications are provided in the oem maintenance manual, may be used 54Nm for all M10 screws. Medium strength liquid thread-locker (i.e. “Loctite”) should be used to secure all screws, bolts and nuts. All screws, bolts and nuts should be checked after driving the first 50 km to ensure that all are tightened to the proper torque.
FOR TO ASSEMBLE THE CRASH PADS, IF YOU ARE NOT A TRAINED MECHANIC, PLEASE CONTACT A SPECIALIST. MOTOPLASTIC, S.A. TAKES NO RESPONSIBILITY FOR DAMAGES CAUSED BY IMPROPER INSTALLATION. THE USE OF CRASH PADS DO NOT GUARANTEE A FULL PROTECTION IN CASE OF ACCIDENT. MOTOPLASTIC-PUIG DECLINE ANY RESPONSIBILITY IN CASE OF MOTORCYCLE DAMAGE.
Accessory verified in the basic configuration of the motorcycle. For models with extra factory settings. We cannot assure its compatibility, except for prior consultation. We decline any eventual claim.
DESCRIPTION
- Plastic cap 2
- M10/150×90 DIN912 screw 1
- M10/150×80 DIN912 screw 1
- M10 DIN125/A washer 4
- Nylon protector 2
- Right aluminum metal spacer (52.5 mm) 1
- Left aluminum metal spacer (47 mm) 1
- Right plate 1
- Left plate 1
- M10/125X60 DIN912 screw 2
- Right metal spacer (Ø20×10) 1
- Left metal spacer (Ø20×4) 1
- M10 DIN6923 nut 2
MOUNTING INSTRUCTIONS
- IT IS NECESSARY TO REMOVE THE COVER
- Created by: www.rrdisseny.cat
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>