FiSMOOL F2 Wireless Charger User Manual

June 13, 2024
FiSMOOL

FiSMOOL F2 Wireless Charger User Manual
Wireless Charger

All technical information s subject o the actual product performance

Product Introduction

The multi-functional wireless charger is an exquisite charging base, which is widely compatible with Qi wireless charging protocol standard. Three dependent coils can be powered by only one line to carry out wireless fast charging for three devices at the same time. When charging your mobile phone, watch and TWS Bluetooth headphone box, as long as you put it on the corresponding charging area, you can automatically charge wirelessly, simplify it and give you a clean desktop. Fashionable appearance design, ABS material, foldable and rotated design, suitable for home, office or travel.

Product Specification

Product Name: Wireless Charger Product Model: F2
Output Power : 15W / 5w/ 3w Input Current : 9V / 34
Output Interface : Type-C Turning Distance: < 8mm

Product Size : 165°73″50mm

Accessories List

Wireless charger : 1, Type-C cable : 1, Product manual : 1

Product Description

Product Description

Power –on White light
Charging Blue light
Standing by White light
FOP Blue light   flashing
Fully Charged White light
Remove equipment Turn to white light within 3 seconds

Use Steps

  1. Please connect product to the 9V / 3A charging adapter through e Type-C interrace and tum on the power.
    Connection

  2. Place your mobile phone, watch and earphone i the designated charging area to star charging,.

  3. Open the stand and you can use it while charging.
    Charging Opening

  4. Fast folding and easy camping.
    Using Instruction

  5. The Been can be rotated about 280 degrees.
    Charge Keeping Instruction

Applicable Devices

  1. Smartphone: complaint models
  2. Smart Watch: Apple Watch 41516718 Apple Watch, Apple Walsh Ture, Apple Watch SE.
  3. Smart Earphone: complaint motels

Note: Please check whether your maybe phono supports wireless charging. 50 the above devices must comply wipe standard,

Safety precautions ( please read it carefully and strictly abide by i )

  1. Keep the charger away from water or other equids.
  2. .In order 1o ensure the maximum performance of the charger, please make sure 1o use the 8V | 3A charging adapter or charging.
  3. Do ot disassemble parts without permission, which may cause product failure or damage.
  4. When using USB wing. please pay attention o the wire piston (o avoid tipping.
  5. Forcibly or valent puling the USB power cable may causa wire damage. Please press the plug o unplug.

Cleaning and maintenance

  1. Clean the cooling holes regularly to avoid blockage.
  2. Clean the surface dir. with a soft cloth dipped with dieted neural emergent, and then wipe it dry wish a dry cloth.
  3. D0 not expose the product o open fry or suing to avoid body deformation
  4. The ambient temperature shall be kept between 045 C.

FCC WARNING

“This device complies with part 16 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmol interference, and (2) this device must acceptancy interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 1o part 15 of the FCC Rules. These limits are designed 1o provide reasonable protection against harmaline reference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no quarantine that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged (o ty to correct the Interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna,
  • increase the separation between the equipment and receive.
  • Connect the equipment into an outie on a circuit different from that to which the receiver s connected.
  • Consult the dealer or an experienced radio TV technician for help

Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsibl for compliance. such modifications could void the user’s authority to operate the equipment

‘The device has been evaluated to meet general RF exposure requirement.
This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled environment. This device and its antennas) must not be co- located o conjunction with any other antenna o transmitter.

Warranty Card

Please keep this card properly. The company will take this card as the warranty certificate Thank you for purchasing this product. The warranty period of this product is 12 months from the date of purchase. Please keep it properly and fill in detailed relevant information for warranty use.

Product model :
Date of purchase :
Dealer name :
User name :

Contact number :
Address :

Explain the reason:| Return goods| Exchange goods| Guarantee
---|---|---|---

Warranty conditions

When warranty service is required, please show this card and fill in the relevant contents in detail. The company provides users with a 12-month warranty period from the date of purchase

Warranty scope

The quality problem under normal use is not the damage caused by external damage, the company assumes the responsibility for repair. In principle, the users of the product during the warranty period do not need to pay fees, but due to human damage, the cost of testing or spare parts shall be charged as appropriate, Products beyond the warranty period will be charged.

Warranty is not available under the following circumstances

Man-made damage: for example, due to damage caused improper use and incorrect use, abnormal wear and tear of appearance, falling damage, circuit destruction, extrusion deformation, entry of foreign matters, moisture, alteration or tearing of sealing labels on products, and any other visible man-made damage, and other conditions, such as the user’s own reasons (unauthorized disassembly and modification, unafraid use, improper operation, water ingress, etc.) Damage caused by force majeure, such as earthquake, flood, fire, typhoon or war.
Made IN CHINA

Documents / Resources

| FiSMOOL F2 Wireless Charger [pdf] User Manual
2BB2B-F2, 2BB2BF2, F2 Wireless Charger, F2, Wireless Charger, Charger
---|---

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Related Manuals