HyperX CP002 ChargePlay Duo Controller Charging Station for PS5 User Guide
- June 13, 2024
- HYPERX
Table of Contents
HyperX CP002 ChargePlay Duo Controller Charging Station for PS5 User Guide
Overview
- A Charging Port
- B USB-C Port
- C USB-C to USB-A Cable
Installation
Connect ChargePlay Duo to PS5 using the supplied USB cable.
Setup
The PS5 system settings must be configured in order to use ChargePlay Duo while the console is in rest mode.
- Navigate to Settings > System > Power Saving > Features Available in Rest Mode > Supply Power to USB Ports
- Adjust the setting to supply power to the USB ports while the console is in rest mode
Usage
The controller light bar will indicate charging status.
- Breathing—Charging
- Off—Fully charged
Questions or Setup Issues?
Contact the HyperX support team at:
hyperxgaming.com/support
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the useris encouraged to try correct the interference by one or more of the following measures:
- Reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. Any special accessories needed for compliance must be specified in the instruction manual.
Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
India RoHS Statement
This product, as well as its related consumables and spares, complies with the
reduction in hazardous substances provisions of the “India E-waste (Management
and Handling) Rule 2016.” It does not contain lead, mercury, hexavalent
chromium, polybrominated biphenyls or polybrominated diphenyl ethers in
concentrations exceeding 0.1 weight % and 0.01 weight % for cadmium, except
for where allowed pursuant to the exemptions set in Schedule 2 of the Rule.
Turkey WEEE Statement
Türkiye Cumhuriyeti: AEEE Yönetmeliğine Uygundur
Charging Product
Model: CP002
©Copyright 2022 HyperX and the HyperX logo are registered trademarks or
trademarks of HP Inc. in the U.S. and/or other countries. All registered
trademarks and trademarks are property of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>