soundcore Flare 2 Portable Speaker User Manual

Flare 2 Portable Speaker
User Manual

Safety Instructions

Avoid dropping.
Do not disassemble.
Avoid extreme temperatures.
Do not use the product outdoors during thunderstorms.
Use original or certified cables.
Do not use any corrosive cleaner/oil to clean.
Do not expose batteries to heat sources such as direct sunlight, fire and or the like.

At a Glance

1. Light effects button
2. Power button
3. Volume buttons ( – / +)
4. Multi-function button
5. Bass Boost button
6. Bluetooth & PartyCast button
7. USB-C charging port

Charging

• Use the included USB cable to charge your speaker and make sure it is fully charged before first use.
• Do not charge your speaker for extended periods.
• When not in use, store your speaker in a cool place.

Powering On/Off

Power on Press
Power off Press and hold for 2 seconds

Bluetooth Pairing

| Press| Enter Bluetooth pairing mode
---|---|---
| Flashing blue| Bluetooth pairing
| Steady blue| Bluetooth connected

• When powered on, the speaker will automatically connect to the last connected device if available within the Bluetooth range. If not, press the Bluetooth button to enter the Bluetooth pairing mode.
• To pair with another device, press the Bluetooth button to re-enter the pairing mode.

PartyCast Mode

Set up one Flare 2 as the primary speaker and connect it with more than 100+ secondary Flare 2 speakers to control audio and all the light effects.
Set up the primary speaker:

1. Connect one Flare 2 speaker to your phone or other devices via Bluetooth. When successfully connected, the Bluetooth LED will turn blue.
2. Press and hold the Bluetooth button on this Flare 2 for 3 seconds until you hear a sound and the Bluetooth LED flashes white to indicate this Flare 2 is the primary speaker.
   • The Bluetooth LED on the primary speaker will keep flashing white.

Connect with secondary speakers:

1. Make sure the secondary speakers aren’t connected to any Bluetooth devices.
   • Press the Bluetooth button to disconnect Flare 2 from a device, the Bluetooth LED will flash blue.

2. Press the Bluetooth button for 3 seconds until you hear a sound and the Bluetooth LED flashes white to indicate the secondary speaker is in connection mode.

3. When the secondary speakers are close to the primary speaker, they will connect to the primary speaker automatically. When successfully connected, the Bluetooth LED on the primary speaker will continue flashing white, while on the secondary speakers will turn white.

When successfully enter the PartyCast mode:

• you can power off, adjust the volume, or switch light effects for all speakers by controlling the primary speaker only;
• you can power off or switch light effects for each secondary speaker individually;
• you can’t adjust the volume for each secondary speaker individually;
• to exit the PartyCast mode, press the Bluetooth button either on the primary speaker or on the primary speaker for 3 seconds until the Bluetooth LED flashes blue.

Button Controls

| |
---|---|---
Play / Pause| | Press
Next track| | Press twice
Previous track| | Press thrice
Bass Boost On / Off| | Press
Volume up / down| | Press
| |
Answer / End a call| | Press
Reject a call| | Press and hold for 2 seconds
| |
Activate Siri or other voice assistant software| | Press and hold for 2 seconds

Light Effects
Download the Soundcore App to check all available light effects.

Soundcore App
Download the Soundcore App for light effects, EQ settings, firmware update and more.

Specifications

Specifications are subject to change without notice.

Playtime
(varies by volume level and content)| 12 hours
Frequency response| 50 Hz – 20 kHz
Bluetooth version| V 5.0
Bluetooth range| 20 m / 66 ft

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>