HYPERX HHSC2X-BA-RD-G Cloud II Wireless Gaming Headset for PC User Manual

: June 12, 2024
: HYPERX

Table of Contents

HYPERX HHSC2X-BA-RD-G Cloud II Wireless Gaming Headset for PC User Manual
Overview
Specifications
Microphone

HYPERX HHSC2X-BA-RD-G Cloud II Wireless Gaming Headset for PC User Manual

Overview

A. Mic mute / mic monitoring button
B. USB charge port
C. Microphone port
D. Status LED
E. Power / 7.1 Surround Sound button
F. Volume wheel
G. Detachable microphone
H. Microphone mute LED
I. USB adapter
J. Wireless pairing pin hole
K. Wireless status LED
L. USB charge cable

Specifications

Headphone
Driver: Dynamic, 53mm with neodymium magnets
Type: Circumaural, Closed back
Frequency response: 15Hz–20kHz
Impedance: 60 Ω
Sound pressure level: 104dBSPL/mW at 1kHz
T.H.D.: ≤ 1%
Weight: 300g
Weight with mic: 309g
Cable length and type: USB charge cable (0.5m)

Microphone

Element: Electret condenser microphone Polar pattern: Bi-directional, Noise- cancelling Frequency response: 50Hz-6.8kHz Sensitivity: -20dBV (1V/Pa at 1kHz)

Battery life * 30 hours
Wireless Range**

GHz Up to 20 meters
*Tested at 50% headphone volume. Battery life varies depending upon the usage.
**Wireless range may vary due to environmental conditions.

Setting up with PC

Connect the wireless USB adapter to the
Power on the
Right click speaker icon > Select Open Sound settings > Select Sound Control Panel
. Under the Playback tab, click on “HyperX Cloud II Wireless” and click on the Set Default button.
Right click on “HyperX Cloud II Wireless” and click on Configure Speakers.
Select 7.1 Surround as the speaker configuration and click next
Under the Recording tab, click on “HyperX Cloud II Wireless” and click on the Set Default button.
Under the Playback tab, verify that “HyperX Cloud II Wireless” is set as Default Device and
Default Communication Device. Under the Recording tab, verify that “HyperX Cloud II
Wireless” is set as Default Device.

Setting up with PlayStation 4

Set Input Device to USB Headset (HyperX Cloud II Wireless)
Set Output Device to USB Headset (HyperX Cloud II Wireless)
Set Output to Headphones to All Audio
Set Volume Control (Headphones) to maximum

Controls

Status LED

Status	Battery Level	LED
Pairing	–	Flash green and red every 0.2s
Searching	–	Slow breathing green

Connected

| 90% – 100%| Solid green
15% – 90%| Blinking green
< 15%| Blinking red

Power / 7.1 Surround Sound button

Hold for 3 seconds to power headset on/off
Press to toggle 1 Surround Sound* on/off
*Virtual 7.1 surround sound outputs as a 2 channel stereo signal to be used with stereo headphones.

Mic mute / mic monitoring button

Press to toggle mic mute on/off
- LED On – Mic muted
- LED Off – Mic active
Hold for 3 seconds to toggle mic monitoring on/off

Volume wheel

Scroll up and down to adjust volume level

WARNING: Permanent hearing damage can occur if a headset is used at high volumes for extended periods of time

Charging the Headset

It is recommended to fully charge your headset before first use.
When charging the headset, the headset status LED will indicate the current charge status.