orlight ORL1009-F-HS Magnetic Downlight Range Instruction Manual
- June 4, 2024
- orlight
Table of Contents
MAGNETIC DOWNLIGHT RANGE
ORL1009-F-HS / ORL1009-F-HS-IP44 /
ORL1019-F-HS / ORL1019-F-HS-IP54
Installation instructions
ORL1009-F-HS Magnetic Downlight Range
ORL1009-F-HS / ORL1009-F-HS-IP44 / ORL1009-F-HS-S /ORL1009-IP44-F-HS-S/
ORL1019-F-HS / ORL1019-F-HS-S / ORL1019-F-HS-IP54
INSTALLATION
Or light does not recommend cutting holes prior to receipt of the product in
hand.
Please see the reverse for full instructions. For further dimensions please
refer to www.orlight.com.
We recommend that this product is installed by a competent person in
accordance with the latest edition of the IET Wiring Regulations BS 7671
“Requirements for Electrical Installations” and the Buildings Regulations, as
may be applicable subject to the location and country of the job or
installation.
For more information and installation guidelines please refer to “Guide on
Lighting Risks and Regulations” which can be downloaded from the website:
http://www.orlight.com/resources/res/31/Orlight_guide_on_lighting_risks_3.pdf
**1. Installation
Step 1 – Cut the aperture in the ceiling. We recommend that a sample hole
is cut in some scrap material to familiarise yourself with the installation.
Step 2 – Allow the lighting cable to drop through the aperture. Connect
mains cabling to the Terminal Block. Ensure all cables are neatly dressed away
from any secondary heat sources.
Step 3 – Press the ceiling spring clips upwards so they lay against the
body of the luminaire and then slot the luminaire into the aperture.
Step 4 – Restore the electricity and check the illumination.
2. Wiring:
Disconnect the mains supply before installation. Ensure that the unit is
installed and maintained by a certified professional and that installation
conforms to any local building control standard applicable.
a. For low voltage installation:
Connect the mains supply to the Or light transformer and the 12V supply from
the Or light transformer to the terminal block provided. Insert the inner ring
into its outer ring counterpart, which will consequently be held in place
magnetically. The fixture may be rotated and tilted to direct light as
required, depending on the fixture type chosen.
b. Mains installation:**
Connect the mains to the terminal block provided. Insert the lamp within the
inner ring and connect it to the lamp holder. Insert the inner ring into its
outer ring counterpart, which will consequently be held in place magnetically.
The fixture may be rotated and tilted to direct light as required, depending
on the fixture type chosen.
- Please note, that all information contained within this instruction manual is provided in good faith. We will not be held responsible for any losses incurred as a result of any inaccuracies contained within this document.
Please note: Standards are dependent on the fixture options.
PLEASE OBSERVE MAXIMUM STANDARDS AS STATED ON FIXTURE SPECIFICATIONS.
www.orlight.com
01923 851 890
Documents / Resources
|
orlight ORL1009-F-HS Magnetic Downlight
Range
[pdf] Instruction Manual
ORL1009-F-HS, ORL1009-F-HS-IP44, ORL1009-F-HS-S, ORL1009-IP44-F-HS-S,
ORL1009-F-HS Magnetic Downlight Range, Magnetic Downlight Range, Downlight
Range
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>