JBL WIND3S Portable Speakers User Guide

June 4, 2024
JBL

JBL top

Bicycle Mount

1 Install the included mounting bracket onto bicycle handlebars.

2 Dock/undock the speaker into the mounting bracket effortlessly

WHAT’S IN THE BOX

 WIND3S

X1 bracket                 X1 non-slip pads(big)

X1 non-slip pads(small)         X1 plastic screw

X1 USB cable                  X1 QSG

BUTTONS
  1. Volume Up
  2. Play/Pause*
  3. Volume Down
  4. Previous Track
  5. Power On / Off
  6. Bluetooth
  7. Next Track

*long press to switch EQ between ‘Sport’ and ‘Bass’ mode

Bluetooth pairing

JBL WIND3S Portable Speakers B2

CHARGING

JBL WIND3S Portable Speakers BA5

WATERPROOF DUSTPROOF IP67

JBL WIND3S Portable Speakers B7

TECH SPEC
Transducer: 43 x 47 mm / 1.5″
Output power: 5 W RMS
Frequency response: 110 Hz – 20 kHz
Signal-to-noise ratio: > 85 dB
Battery capacity: 1050 mAh
Battery charge time: 2.5 hours (5 V 1 A)
Music play time: up to 5 hours (dependent on volume level and audio

content)
Bluetooth® version:| 5.0
Bluetooth® profile:| A2DP 1.3, AVRCP 1.6
Bluetooth® transmitter frequency range:| 2400 MHz – 2483.5 MHz
Bluetooth® transmitter power:| <6 dBm (EIRP)
Bluetooth® transmitter modulation:| GFSK, π/4 QPSK, 8DPSK
Dimensions (W x H x D):| 90 mm x 73.2 mm x 35.8 mm
Weight:| 0.230 kg
Maximum operation temperature:| 45 °C

To protect battery lifespan, fully charge at least once every 3 months. Battery life will vary due to usage patterns and environmental conditions.
Do not expose the JBL Wind 3S to liquids without removing cable connection. Do not expose JBL Wind 3S to water while charging. It may result in permanent damage to the speaker or power source. Chemicals, salt or “foreign particles” in your pool or the ocean can damage the waterproof seals or harm the connector surface over time if not rinsed off after use. After a liquid spill or rinse, do not charge your speaker until it’s completely dry and clean. Charging when wet might damage your speaker.
When using an external adapter, the output voltage/ current of the external adapter should not exceed 5V/3A.

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.

EAC

CA_JBL_WIND3S_QSG_Global_SOP_V12

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals