Puig Pro 2.0 Frame Sliders Installation Guide
- June 12, 2024
- Puig
Table of Contents
Puig Pro 2.0 Frame Sliders
INSTRUCTIONS TO ASSEMBLE
Remove the fasteners that subject the chassis to the engine. Mount the protectors on each own side as the figure below shows. Tight the set, and place the caps.
All the screws replaced, should be tightened to the torque specified in the oem maintenance manual for your motorcycle. if no torque specifications are provided in the oem maintenance manual, may be used 54Nm for all M10 screws.
Medium strength liquid thread-locker (i.e. “Loctite”) should be used to secure all screws, bolts and nuts. All screws, bolts and nuts should be checked after driving the first 50 km to ensure that all are tightened to the proper torque.
Accessory verified in the basic configuration of the motorcycle. For models with extra factory settings. We cannot assure its compatibility, except for prior consultation. We decline any eventual claim.
DESCRIPTION
| DESCRIPTION | QTY. |
|---|---|
| Plastic cap | 2 |
| M10/150×80 DIN912 screw | 2 |
| M10 DIN125/A washer | 2 |
| Nylon protector | 2 |
| Right aluminium metal spacer | 2 |
| Right plate | 1 |
| Left plate | 1 |
| M10/125X60 DIN912 screw | 2 |
| M10 DIN6923 nut | 2 |
MOUNTING INSTRUCTIONS
RIGHT SIDE
LEFT SIDE
CUSTOMER SUPPORT
Created by: www.rrdisseny.cat
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>