iVSEC RG59 Single Port Long Reach Ethernet Over Coaxial Extender User Manual

: June 12, 2024
: iVSEC

Table of Contents

Important Safeguards and Warnings
Product Overview
Device Structure
Appendix 1 PoE Power Supply Specifications (RG59 Coaxial Cable)
Documents / Resources

RG59 Single Port Long Reach Ethernet Over Coaxial Extender
User Manual

Important Safeguards and Warnings

Attention:
Please read the following safeguards and warnings carefully before using the product in order to avoid damages and losses.
Note

Do not expose the device to lampblack, steam or dust. Otherwise it may cause fire or electric shock.
Do not install the device at position exposed to sunlight or in high temperature. Temperature rise in device may cause fire.
Do not expose the device to humid environment. Otherwise it may cause fire.
The device must be installed on solid and flat surface in order to guarantee safety under load and earthquake. Otherwise, it may cause device to fall off or turnover.
Do not place the device on carpet or quilt.
Do not block air vent of the device or ventilation around the device. Otherwise, temperature in device will rise and may cause fire.
Do not place any object on the device.
Do not disassemble the device without professional instruction.

Warning:

Please use battery properly to avoid fire, explosion and other dangers.
Please replace used battery with battery of the same type.
Do not use power line other than the one specified. Please use it properly. Otherwise, it may cause fire or electric shock.

Special Announcement

This manual is for reference only.
All the designs and software here are subject to change without prior written notice.
All trademarks and registered trademarks are the properties of their respective owners.
If there is any uncertainty or controversy, please refer to the final explanation of us.
Please visit our website for more information.
The function of the ITE being investigated to EN 62368-1 is considered not likely to require connection to an Ethernet network with outside plant routing, including campus environment.
The installation instructions clearly state that the ITE is to be connected only to PoE networks without routing to the outside plant.

Product Overview

1.1 Product Introduction

Single-Port Long Reach Ethernet over Coaxial Extender is a type of converter from RJ45 to BNC port, Which supports long range power supply transmission via coaxial cable. It provides one BNC coaxial port and one RJ45 port.
The product is equipped with two transmission modes which are 100Mbps and 10Mbps. It can be modified according to the transmission distance.

1.2 Product Features

Supports IEEE802.3, IEEE802.3u and IEEE802.3X standards.
Supports IEEE802.3af and IEEE802.3at power supply standards.
Port: 1RJ45 10/100Mbps, 1BNC.
Supports RG59 coaxial cable: 400m/100Mbps, 1000m/10Mbps.
Supports MDI/MDIX self-adaption.
Supports long range power supply transmission via coaxial cable.
Operating temperature:-3065°C.

1.3 Typical Application
The product is divided into transmitter and receiver. The typical application is shown in Figure 1-1.

iVSEC RG59 Single Port Long Reach Ethernet Over Coaxial Extender -
Application

Device Structure

2.1 Device Panel
The device panel is shown in Figure 2-1 (transmitter) and Figure 2-2 (receiver).

iVSEC RG59 Single Port Long Reach Ethernet Over Coaxial Extender - Device
Panel

Please refer to table 2-1 for more details

SN	Name	Note
1	PoE OUT	PoE output port
2	PoE IN	PoE input port
3	Link	BNC port Link indicator light

E100: On for 3 seconds, off for 1 second
E10: On for 1 second, off for 1 second
4| PWR| Power indicator light
5| Long Reach| Coaxial cable port

Table 2-1

Appendix 1 PoE Power Supply Specifications (RG59 Coaxial Cable)

Cable Length (m)| Communication Bandwidth (Mbps)| PoE Max Load Capacity (W)| Network Operating Mode
---|---|---|---
100| 100| 21| E100
200| 100| 15| E100
300| 100| 11| E100
400| 100| 9| E100
500| 10| 7| 0.00E+00
800| 10| 5| 0.00E+00
1000| 10| 4| 0.00E+00
ePoE switch supply voltage 48V.
RG-59, max. DC resistance < 50/100m.
Caution: The load capacity can be applied to networking scheme 3. Cable length means the total wire length from switch to transmitter (including network cable and coaxial cable). It can use max. 2m network cable to connection transmitter to IPC.
100| 100| 26.| E100
200| 100| 24| E100
300| 100| 19| E100
400| 100| 16| E100
500| 10| 13| 0.00E+00
800| 10| 8| 0.00E+00
1000| 10| 6| 0.00E+00
ePoE switch supply voltage 53V.
RG-59, max. DC resistance < 50/100m.
Caution: The load capacity can be applied to networking scheme 3. Cable length means the total wire length from switch to transmitter (including network cable and coaxial cable). It can use max. 2m network cable to connection transmitter to IPC.

Note

This user’s manual is for reference only.
Slight difference may be found in user interface.
All the designs and software here are subject to change without prior written notice.
All trademarks and registered trademarks are the properties of their respective owners.
If there is any uncertainty or controversy, please refer to the final explanation of us.
Please visit our website for more information.

V1.0.5

Documents / Resources

| iVSEC RG59 Single Port Long Reach Ethernet Over Coaxial Extender [pdf] User Manual
RG59, RG59 Single Port Long Reach Ethernet Over Coaxial Extender, Single Port Long Reach Ethernet Over Coaxial Extender, Long Reach Ethernet Over Coaxial Extender, Ethernet Over Coaxial Extender, Coaxial Extender, Extender
---|---