Bestway 65346 Stand Up Paddleboard Instruction Manual
- June 12, 2024
- Bestway
Table of Contents
- Bestway 65346 Stand Up Paddleboard
- Product Information
- Product Usage Instructions
- Maintenance and Storage Instructions
- Repair Instructions
- WHAT INBOX
- IMPORTANT SAFETY INSTRUCTIONS
- TECHNICAL SPECIFICATIONS
- INSTALLATION OF THE SUP
- USAGE OF THE SUP
- MAINTENANCE AND STORAGE OF THE SUP
- REPAIR
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Bestway 65346 Stand Up Paddleboard
Product Information
The product is an inflatable SUP (Stand-Up Paddleboard) with the following specifications:
- Item : 65346
- Inflated Size: 3.05m x 84cm x 15cm (10′ x 33′ x 6′)
- Recommended Maximum Load Capacity: 130kg (287lbs)
- Maximum Number of Persons: 1 Adult
- Working Pressure: 1.03 bar (15psi)
Product Usage Instructions
To use the SUP, follow the below steps:
- Adjust the length of the oar before using the SUP (refer to Fig 1).
- Kneel on the board (refer to Fig 2).
- Gradually stand up on one leg (refer to Fig 3).
- Stand up with the other leg and keep your hands on the board (refer to Fig 4).
- Maintain balance with paddle (refer to Fig 5).
- Keep knees slightly bent, increase the balance buffer, and start rowing (refer to Fig 6).
- Begin to row after standing up (refer to Fig 7).
Maintenance and Storage Instructions
To maintain and store the SUP, follow the below steps:
- Disassemble the fin (refer to Fig 1).
- Deflate the SUP by pushing on the pin and rotating clockwise (refer to Fig 2).
- Fold the SUP, but not more than 10 cm every time (refer to Fig 3).
- Pack the SUP (refer to Fig 4).
- Insert the SUP into the bag (refer to Fig 5).
Repair Instructions
To repair the SUP, follow the below steps:
- Deflate the board (refer to Fig 1).
- Clean around the surface around the leak (refer to Fig 2).
- Cut the repair patch to the suitable size (refer to Fig 3).
- Apply the glue and patch on the damaged surface (refer to Fig 4).
- Press the repair patch for 30 seconds (refer to Fig 5).
- Wait 24 hours before use (refer to Fig 6).
WHAT INBOX
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS.
- Carefully read, understand, and follow all information in this user manual before inflating and using the SUP.
- These warnings, instructions, and safety guidelines address some common risks during the use of the SUP, but they cannot cover all risks and dangers in all cases. For your own safety, always heed the advice and warnings in these instructions. Non-compliance with these operating instructions may expose you to serious danger or death. Only use the product in the places and conditions for which it is intended.
- Safekeeping the instruction. If instruction is missing, search it in website www.bestwaycorp.com/support.
- Stand-up Paddling is a dangerous sport. Use of this product exposes the user to unexpected risks, dangers and hazards.
- User should realize and understand these risks. The use of this product implies the respect of the safety instructions described in the manual.
- Regardless of the number of persons on board, the total weight of persons and equipment must never exceed the maximum recommended load.
- Do not use this product if you are under the influence of alcohol, drugs or medications.
- Life saving devices such as life jackets and buoys should be pre-inspected and used at all times. Always paddle with an experienced partner when using this product.
- Tell your sail routes and time schedule to your partner.
- Check the weather forecast first to know the marine environment and weather conditions before starting. Bad weather and marine environment is very dangerous. Never use this product in conditions that are beyond your ability (such as, but not limited to, high surf, riptides, currents or river rapids)
- Use the product near the shore and beware of natural factors such as wind, tidewaters and tidal waves. BE AWARE OF OFFSHORE WINDS AND CURRENTS.
- Before every use, carefully inspect the product for signs of wear or leakage to ensure everything is in good condition. Please do not use the SUP if you find any damage. Do not surf in unfamiliar water areas.
- Beware of potential harmful effects of liquids such as battery acid, oil and petrol. These liquids may damage the product. Inflate according to the rated pressure on the product or it will cause over inflation and/or an explosion.
- Stay balanced. Uneven distribution of loads on the board may cause the board to overturn which could lead to drowning.
- Know how to operate this product. Check your local area for information and/or training as needed.
- Inform yourself about local regulations and dangers related to surfing, boating and/or other water activities.
- The air pressure gauge of the hand pump only shows the air pressure higher than 5 psi, which is normal. When the air pressure in the product is lower than 5 psi, the air pressure gauge will not show a value.
- Extended exposure to sun can shorten the lifespan of your SUP. We suggest not leaving SUPs in direct sunlight for more than 1 hour after use.
- Store in a cool, dry place and out of children’s reach.
- Do not unfold this product when the temperature is low. The product should be placed at room temperature (over 20˚C) for 24 hours before inflation. Deflate completely before folding the SUP.
- Take the SUP out from the bag and refer to the packaging steps for long-term storage.
TECHNICAL SPECIFICATIONS
Item
|
Inflated Size
| Recommended Working Pressure| Maximum Load Capacity| Maximum
Number of Persons
---|---|---|---|---
65346| 3.05m x 84cm x 15cm (10′ x 33″ x 6″)| 1.03bar (15psi)
| 130kg (287lbs)
| 1 Adult
INSTALLATION OF THE SUP
For the installation instructions, read the drawings inside the manual. Drawings are for illustration purpose only. May not reflect actual product. Not to scale.
- Open the inflation valve, push on the pin and rotate anticlockwise. (Fig 1).
- Connect the inflation hose to the inflation valve (Fig 2).
- Inflate the SUP to 1.03 bar (15 psi) (Fig 3).
- Close the valve before use (Fig 4).
- Install the safety rope (Fig 5 & 6).
- Install the fin (Fig 7).
- Assemble the oar (Fig 8).
- Completion (Fig 9).
USAGE OF THE SUP
For the usage instructions, read the drawings inside the manual. Drawings are for illustration purpose only. May not reflect actual product. Not to scale.
- 1. Adjust the length of oar before using the SUP (Fig 1).
- Kneel on the board (Fig 2).
- Gradually stand up on one leg (Fig 3).
- Stand up with the other leg and keep your hands on the board (Fig 4).
- Maintain balance with paddle (Fig 5).
- Keep knees slightly bent, increase the balance buffer and start rowing (Fig 6).
- Begin to row after standing up (Fig 7).
MAINTENANCE AND STORAGE OF THE SUP
For the maintenance and storage instructions, read the drawings inside the manual. Drawings are for illustration purpose only. May not reflect actual product. Not to scale.
- 1. Disassemble the fin (Fig 1).
- Deflate the SUP by pushing on the pin and rotating clockwise. (Fig 2).
- Fold the SUP, but not more than 10 cm every time (Fig 3).
- Pack the SUP (Fig 4).
- Insert the SUP in bag (Fig 5).
REPAIR
For the repair instructions, read the drawings inside the manual. Drawings are for illustration purpose only. May not reflect actual product. Not to scale.
- Deflate the board (Fig 1).
- Clean around the surface around the leak (Fig 2).
- Cut the repair patch to the suitable size (Fig 3).
- Apply the glue and patch on the damaged surface (Fig 4).
- Press the repair patch for 30 sec (Fig 5).
- Wait 24 hours before use (Fig 6).
Visit www.bestwaycorp.com/support. for help WE SUGGEST NOT TO RETURN THE PRODUCT TO THE STORE QUESTIONS. PROBLEMS? MISSING PARTS? For FAQs, Manuals, Videos, Or Spare Parts, Please Visit bestwaycorp.com/support.
- ©2022 Bestway Inflatables & Material Corp.
- All rights reserved
- Trademarks used in some countries under license from
- Bestway Inflatables & Material Corp., Shanghai, China
- Manufactured, distributed and represented in the European Union by
- Bestway Central & South America
- Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/9
- Tel Australia: (+61) 2 9037 1388; New Zealand: 0800 142 101
- Distributed in United Kingdom by Bestway Corp UK Ltd. 8 Wentworth Road, Heathfield Industrial Estate, Newton Abbot, Devon, TQ12 6TL
- Exported by
- Bestway (Hong Kong) International Ltd.
- Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon, Hong Kong
- www.bestwaycorp.com.
- bestwaycorp.com/support.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>