velleman WSL193 3D LED Cube Instruction Manual
- June 12, 2024
- Velleman
Table of Contents
velleman WSL193 3D LED Cube
Product Information
- R1: 10K resistor
- R2: 10 ohm resistor
- R3…R5: 2K2 resistors
- Ceramic capacitors: unspecified
- Quartz Crystal: unspecified
- Diode: D2
- IC-Socket: unspecified
- Electrolytic capacitors: unspecified
- Voltage regulator: UA7805
- IC: unspecified
- Male Header: unspecified
- IC1: VMK193 (programmed PIC18F14K50-I/P)
- Battery snap: E9V (Red/Black)
- SK1: USB connector
- SK2: USB
- SK3: unspecified
- SK4: 12pins
- C1, C2, C8, C9: 100nF (104) capacitors
- X1: 12MHz crystal
- C4, C5: 22pF (22) capacitors
- C6: 470nF (474) capacitor
- D1…D3: 1N4007 diodes
- Push button: unspecified
- IC1: 20p
- Transistor: unspecified
Product Usage Instructions
- Assembly of the LEDs:
- Bend the LED pins by 2mm.
- Solder the LEDs.
- Repeat steps a and b for a total of 6 LEDs.
- Additional Manual Assembly of the LED’s:Refer to the additional manual for the assembly process of LED components C1, C2, C8, C9.
- Other Steps:
- Solder components D1, D2, and D3.
- Solder components T1, T2, and T3.
- Cut component A.
- Solder component C.
- Solder components C4, C5, and C6.
- Connect SK1 (USB connector) to the designated location.
- Connect SK2 (USB) to the designated location.
- Connect SK3 to the designated location.
- Connect SK4 (12pins) to the designated location.
Please note that this response provides only partial information from the user manual. Refer to the complete manual for detailed instructions and additional information.
Soldering
Component side
MK193B
Resistor
- R1: 10K: (Brown, Black, Orange)
- R2: 10 ohm: (Brown, Black, Black)
- R3…R5: 2: (Red, Red, Red)
- R6…R14: 270: (Red, Purple, Brown)
Ceramic capacitors
- C1, C2, C8, C9: 100nF (104)
Quartz Crystal
- X1: 12MHz
Diode
- Watch the polarity
- D1…D3 : 1N4007
IC-Socket
- Watch the notch !
- IC1 : 20p
Female header
- SK1
Cercamic capacitors
- C4, C5: 22pF (22)
- C6: 470nF (474)
Push button
- SW1: Next/speed
Transistor
- T1…T3: BC557B
USB connector
- SK2: USB
- SK4: 12pins
Electrolytic capacitors
- Watch the polarity
- C10: 4,7μF
- C11:470μF
Voltage regulator
- VR1 : UA7805
IC
- Watch the notch
- IC1: VMK193 (programmed PIC18F14K50-I/P)
Battery snap
- IC1: VMK193 (programmed PIC18F14K50-I/P)
Male Header
- MK193T
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>