ITC 69517 Pin Courtesy Light Installation Guide

ITC 69517 Pin Courtesy Light

Pin Courtesy Light
Part#: 69516, 69517

Product Information

• The Pin Courtesy Light is a lighting accessory for various applications.
• It is available in two different models: Part# 69516 and Part# 69517.
• The light requires a 12V DC power source for operation.
• The light can be used with or without a bezel, depending on the desired installation method.
• The light is designed to be mounted on a surface using a power drill.

Installation Instructions

1. Without Bezel:
   • Use a power drill to create a hole of 0.375 inches for single-color lights or 0.5 inches for RGB(W)/addressable lights in the mounting surface.
   • Attach the wires to the power source. The red wire is positive and the black wire is neutral.
   • Slide the light off the rubber grommet, install the rubber grommet into the hole, and then slide the light back into the grommet.
2. With Bezel:
   • Remove the rubber grommet and discard it.
   • Use a power drill to create a hole of 0.4375 inches in the mounting surface.
   • Attach the wires to the power source. The red wire is positive and the black wire is neutral.
   • Slide the bezel and light into the mounting surface.

If you have any further questions or need assistance, please contact us: 3030 Corporate Grove Dr. Hudsonville, MI 49426

Phone: 616.396.1355
Website: itc-us.com

PARTS/TOOLS NEEDED:

Pin Light

Power Drill (Not Provided)

INSTALLATION CONSIDERATIONS

• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Disconnect power before installing, adding, or changing any component.
• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
• The brushed nickel bezel can be used in interior applications only.
• LEDs are polarity sensitive and will not light if not attached properly.

WITHOUT BEZEL:

• Drill a 0.375” for single color or 0.5” for RGB(W)/addressable hole in the mounting surface
• Attach wires to the power source. Red is positive and black neutral
• Slide light off the rubber grommet, install rubber into the hole, and then slide the light back into the grommet

WITH BEZEL:

• Remove the rubber grommet and throw away
• Drill a 0.4375” hole in mounting surface
• Attach wires to the power source. Red is positive and black neutral
• Slide the bezel and light into the mounting surface

3030 Corporate Grove Dr. Hudsonville, MI 49426 Phone: 616.396.1355
itc-us.com

For warranty information please visit www.itc-us.com/warranty-return- policy
Rev C • 06/26/23

References

• ITC Warranty & Return Policy

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>