maze Products MWT-100 100L Tank Kit Instruction Manual
- June 12, 2024
- maze Products
Table of Contents
100L Tank Kit – Installation Instructions
Instruction Manual
This slimline water tank is designed to collect rainwater from downpipes which can be used to water the garden. Tanks can be linked together to increase the amount of water that is being collected and used.
Components
Stand
Make sure you find a level area to place the stand. Join the 3 parts as shown:
Tap
Simply thread the tap into the hole at the bottom of the tank.
Make sure the tap is screwed all the way in without over tightening. Please
note that some force may be required to pusthe tap in and then turn at the
same time so it is threaded. 
Connecting the Downpipe Diverter
The Maze diverter is simple to install and allows you to collect rainwater from your downpipe without the water tank overflowing when full. The tank can either be positioned next to your downpipe or further away via an extended hose.
- Drill a 25mm hole in the water tank. There are indented flat circles in the rim of the tank where it is ideal to make the hole.
- Push the connection tank fitting through the hole and tighten the nut to hold it in place. nut to hold it in place. (See pic 1)
- Place the water tank next to the downpipe (if using the stand place tank on it). A 30mm section now needs to be removed from the downpipe. Mark 10mm below the top of the water tank. Mark again 30mm below this point. Using a 30mm below this point. Using a hacksaw cut out this section. (See pic 2)
- Fit diverter body with rectangular end upright into the cut section of the downpipe. You may need to remove your downpipe brackets in order to do this.
- Connect the hose between the diverter and the water the diverter and the water tank connector. (See pic3)
Linking tanks together
The Linking Kit allows you to connect many tanks together to achieve the desired storage capacity.
- Drill a 25mm hole in the water tank. There are indented flat circles in the rim of the tank where it is ideal to make the hole.
- Push the connection tank fitting through the hole and tighten the nut to hold it in place. (See pic 1)
- Perform steps 1 & 2 on the second tank. (See pic2)
- The distance between the tanks can be extended by simply using a longer pipe between the tanks. Connect the hose between two water tank connectors. (See pic3)
Products
For enquiries or spare parts please contact Maze:
1300 449 107 or info@mazeproducts.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>