Vento Barine Ceiling Fan Instructions

Vento Barine Ceiling Fan

SAFETY INSTRUCTIONS

• Protection class I: The fitting has an earthing connection: The earth wire (yellow/green) has to be connected to the clip marked with .
• The fitting should only be installed in rooms where direct contact with water is impossible.
  • Light source (yes / not included).
  • Remote control, included.
  • This device children can use it with age of 8 years or more and people with physical, sensory or mental small capacities, if they has been given them the supervision or adapted training. The children must not play with the fans. The cleanliness and the maintenance must be done by an adult.

WARNINGS

1. Read the entire booklet carefully before beginning installation and save these instructions.
2. To reduce the risk of personal injury, attach the fan directly to the support structure of the building according to these instructions, and use only the hardware supplied.
3. To avoid possible electrical shock, before installing your fan, disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch lo-cation.
4. For the electrical connection, it is necessary to incorporate an isolator switch according to the installation regu-lations, which ensures all-pole cut, directly connected to the power terminals and it must have a contact separation in all its poles, which provides total disconnection under category III surge conditions.
5. All wiring and connections must be made in accordance with national and local electrical codes. If you are not familiar with the way to do the electrical installation, you must use the services of a qualified electrician.
6. Make sure that the fan is disconnected from the mains before removing the protection.
7. To reduce the risk of personal injury, do not bend the blade attachment the system when installing, balancing or cleaning the fan. Never insert foreign objects between rotating fan blades.
8. To reduce the risk of fire, electrical shock or motor damage, do not lift or carry the fan by the lead wires.
9. The fan blades cannot be installed lower than 2,3m from the floor.
   The important precautions, safeguards and instructions appearing in this manual are not meant to cover all pos-sible conditions and situations that may occur. It must be understood that common sense, caution, and carefulness are factors that cannot be built into this product. These factors must be supplied by the person(s) installing, caring for and operating the unit.

Tools and materials required

Verify you have all parts before beginning the installation. Check the foam insert closely for missing parts. Remove the motor from packing. To avoid damage to the finish, assemble motor on a soft padded surface or use the original foam inset in the motor box. Do not lay fan on its side as this could result in the shifting of the motor in the decorative enclosure.

HOW TO INSTALL THE FAN

Place the fan.
Be sure that the connections are made properly. If in doubt consult a technician.

Hanging the fan. Make sure the screws are tightened. Installing the light fixture kit.

PRE-CODED REMOTE CONTROL

OPERATIONS WITH THE TRANSMITTER

1. Fan on and speed
2. On off for light and Light temperature
3. With Programmer: It will work for 1h, 2h, 4h, 8h
4. Off for fan

BALANCE CONTROL

www.acbiluminacion.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>