hansgrohe 31954000 Waterforms Bath Mixers Instructions
- June 12, 2024
- hansgrohe
Table of Contents
Instructions for use
assembly instructions
31954000 Waterforms Bath Mixers
**** Safety Notes
Glovesshouldbewornduringinstallationtoprevent crushing and cutting
injuries.
Theproductmayonlybeusedforbathing,hygienic and body cleaning purposes.
**** Thehotandcoldsuppliesmustbeofequal pressures.
Installation Instructions
- Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
- The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
- The plumbing codes applicable in the respective countries must be observed.
- The diverter (type HC) installed in the bath mixer is designed as an anti-retraction device. For this reason, the lower edge of the diverter must be at least 25 mm above the highest possible dirty water level.
Technical Data
Operatingpressure: max.1MPa
Recommendedoperatingpressure: 0,1-0,5MPa
Testpressure: 1,6MPa (1MPa=10bar=147PSI)
Hotwatertemperature: max.60°C
Thermaldisinfection: 70°C / 4 min
- Safety against backflow
- The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
| Fault | Cause | Remedy |
|---|---|---|
| Insufficient water | – check valve hasn’t moved back | – Exchange check valves |
| – Shower filter seal dirty | – Clean filter seal between shower and hose | |
| Mixer stiff | – Cartridge defective, calcified | – Exchange cartridge |
| Mixer dripping | – Cartridge defective | – Exchange cartridge |
| Hot water temperature too low | – Hot water limiter incorrectly set | – Set hot |
water limiter
Instantaneous heater didn’t work| – Flow limiter in handshower isn’t removed|
– Remove flow limiter
– Clean filter seal between shower and hose
– Shower filter seal dirty
– check valve hasn’t moved back| – Exchange check valves
Assembly (see page 34)
Adjustment (see page 36)
To adjust the hot water limiter. Using a hot water limiter in combination with
a continuous flow water heater is not recommended.
Maintenance (see page 40)
The check valves must be checked regularly according to EN 806-5 in accordance
with national or regional regulations (at least once a year).
Dimensions (see page 33)
Flow diagram (see page 33)
Spare parts (see page 39)
Cleaning (see page 37)
Operation (see page 38)
Dimensions
Flow diagram
Assembly
Adjustment
Cleaning
Cleaning recommendation / Warranty / Contact
| | 
| 
---|---|---|---
www.hansgrohe.com/cleaning-recommendation| www.hansgrohe.com/cleaning-
recommendation|
www.hansgrohe.com/cleaning-recommendation| www.hansgrohe.com/cleaning-
recommendation
Operation
Spare parts
Maintenance
Auestraße 5 – 9 · D-77761 Schiltach
Telefon +49 (0) 78 36/51-1282
Telefax +49 (0) 7836/511440
E-Mail: info@hansgrohe.com
Internet: www.hansgrohe.com
01/2022
908879.01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>