hansgrohe 71463000, 71464000 Vernis Shape Instruction Manual
- June 12, 2024
- hansgrohe
Table of Contents
hansgrohe 71463000, 71464000 Vernis Shape
OTHER MODELS
Vernis Shape
71463000 / 71464000
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting
injuries.
The product may only be used for bathing, hygienic and body cleaning purposes.
The hot and cold supplies must be of equal pressure
Installation Instructions
- Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
- The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
- The plumbing codes applicable in the respective countries must be observed.
Technical Data
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 – 0,5 MPa
Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 60°C
Thermal disinfection: 70°C / 4 min
- The product is exclusively designed for drinking water!
- Safety against backflow
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 35)
To adjust the hot water limiter. Using a hot water limiter in combination with
a continuous flow water heater is not recommended.
Dimensions (see page 36)
Flow diagram (see page 36)
Spare parts (see page 40)
Cleaning (see page 37)
Operation (see page 38)
Test certificate (see page 34)
Adjustment
Dimensions
Flow diagram
Spare parts
Vernis Shape
71463000 / 71464000
Cleaning
www.honsgrohe.com/cleaning-recommendation
Cleaning recommendation
www.honsgrohe.com/cleaning-recommendation
Warranty
www.honsgrohe.com/cleaning-recommendation
Contact
www.honsgrohe.com/cleaning-recommendation
Operation
Vernis Shape 71463000
open
close
hot
cold
Vernis Shape 71464000 
close
hot
cold
Test certificate
71463000 P-IX 38130/IOB
**71464000
**
SPECIFICATION
| Fault | Cause | Remedy |
|---|---|---|
| Insufficient water | – filter insert shower dirty | – Clean filter insert |
between shower and hose
– Aerator calcified, dirty| – Clean aerator, replace as necessary
Mixer stif| – Cartridge defective, calcified| – Exchange cartridge
Mixer dripping| – Cartridge defective| – Exchange cartridge
Hot water temperature too low| – Hot water limiter incorrectly set| – Set hot
water limiter
Instantaneous heater didn’t work| – Flow limiter in hand shower isn’t removed|
– Remove flow limiter
| – Shower filter seal dirty| – Clean filter seal between shower and hose
Assembly
CUSTOMER SERVICES
Hansgrohe · Auestraße 5 – 9 · D-77761 Schiltach · Telefon +49 (0) 78
36/51-1282 · Telefax +49 (0) 7836/511440
E-Mail: info@hansgrohe.com
Internet: www.hansgrohe.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>