hansgrohe Vernis Blend 210 , Vernis Shape 210 Installation Guide
- June 12, 2024
- hansgrohe
Table of Contents
- hansgrohe Vernis Blend 210 , Vernis Shape 210
- Product Information
- Product Usage Instructions
- Safety Notes
- Installation Instructions
- Assembly
- Technical Data
- Adjustment
- Dimensions
- Spare parts
- Cleaning
- Operation
- Test certificate
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
hansgrohe Vernis Blend 210 , Vernis Shape 210
Product Information
The product is a Vernis Blend 210 71554000. It is a bathing and
hygiene product designed for body cleaning purposes. The product
has specific safety instructions and technical specifications that
need to be followed for proper use.
Safety Instructions
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The product may only be used for bathing, hygienic, and body cleaning purposes.
- The hot and cold supplies must be of equal pressure.
Specifications
- Operating pressure: maximum 1 MPa
- Recommended operating pressure: 0.1 – 0.5 MPa
- Test pressure: 1.6 MPa
- Hot water temperature: Thermal disinfection
- Do not use silicone-containing acetic acid
Product Usage Instructions
- To ensure proper usage of the Vernis Blend 210 71554000, follow the instructions below:
- Installation Instructions
- Refer to page 32 of the user manual for detailed installation instructions.
- Cleaning
- For cleaning instructions, refer to page 37 of the user manual.
- Operation
- Refer to page 40 of the user manual for instructions on how to operate the product.
- Adjustment
- To adjust the hot water limiter, follow the instructions on page 35 of the user manual. Note that using a hot water limiter in combination with a continuous-flow water heater is not recommended.
- Flow Chart
- For a visual representation of the flow diagram, see page 36 of the user manual.
- Spare Parts
- If any parts need replacement, refer to page 39 of the user manual for a list of spare parts.
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The product may only be used for bathing, hygienic and body cleaning purposes.
- The hot and cold supplies must be of equal pressures.
Installation Instructions
- Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honored.
- The pipes and the fixture must be installed, flushed, and tested as per the applicable standards.
- The plumbing codes applicable in the respective countries must be observed.
- The drain valve must only be used as intended. It is not allowed to attach other objects to the drain valve, for example, a semi-pedestal.
- The EcoSmart® (flow limiter) in the basic body can be removed if there are problems with the flow heater or if a higher water throughput is required.
Assembly
Technical Data
This mixer series-produced with EcoSmart® (flow limiter)
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
- Hot water temperature : max. 60°C
- Thermal disinfection : 70°C / 4 min
- The product is exclusively designed for drinking water
Adjustment
Adjust the hot water limiter. Using a hot water limiter in combination with a
continuous-flow water heater is not recommended
Dimensions
Spare parts
- Special accessories (order as an extra)
- special tool #58085000
Cleaning
Operation
- Hansgrohe recommends not to use as drinking water the first half liter of water drawn in the morning or after a prolonged period of non-use.
Test certificate
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>