Hanover HLOUISECHR-1FLR Louise Floor Lamp Instruction Manual
- June 12, 2024
- HANOVER
Table of Contents
Assembly & Care Guide
HLOUISECHR-1FLR Louise Floor Lamp
The model number of your lighting is printed on the side of your carton.
Always use this number to identify your lighting.
Thank you for your purchase of this quality lighting. With proper use and
care, your lighting will provide you with years of use. Please follow the
instructions on how to install your lighting. If you should have any problems
with your lighting DO NOT return it to the place of purchase. Please call our
toll free number: 877-397-5144 and a
customer service representative will assist you.
Please read all instructions completely before installing your lighting.
NOTE: It is recommended to contact a licensed electrical contractor for
installation.
WARNING: To reduce the risk of fire, electric shock, or personal injury:
- Turn off /unplug lamp and allow to cool before replacing bulb.
- Do not touch bulb when fixture is turned on.
- Do not look directly at lighted bulb.
- Keep materials that burn easily away from lighted bulb.
CLEANING
Use only soft cloth to dust and clean fixture. Never use chemicals or abrasive cleaners as it may damage finish.
Installation Instruction
Item No: HLOUISEGLD-1FLR HLOUISECHR-1FLR
- Carefully unpack and take out the parts as picture shown.
- Place the screw (B) through lock washer (C), iron washer (D), marble base (E), iron sheet (F) into the steel pipe (G), then tighten the screw (B) with the wrench (A).
- Place the wheel (H) through the steel pipe, then place the screw (J) through the holes of the steel pipe into the wheel (H) and tighten with screwdriver (K).
- Screw the turn-knob (L) through steel pipe (G) into the wheel (H).
- Place the fabric shade (P) onto the socket (O), and secure with the socket ring (Q).
Note:
Swing turn-knob (L) is only to adjust arm (I) up and down, not side to side.
Swing wheel (M) is only to adjust arm (N) side to side, not up and down.
Note: 120V/100W
1-Year Limited Warranty
“Limited” Warranty Program
For a period of one (1) year after purchase, Hanover Products (“Manufacturer”)
will either repair or replace defective components in accordance with this
Limited Warranty.
Sales and use taxes, plus shipping and handling charges are the responsibility
of the consumer.
This warranty is between Manufacturer and the original purchaser and is valid
only when accompanied by the original purchaser’s sales receipt showing
original date of purchase and location of purchase. Replacements under this
warranty revert back to the date of original purchase for future warranty.
Manufacturer or its authorized dealer can accept or reject warranty claims
based on its findings. This warranty applies in normal residential use only,
where an issue with the product is due to a defect in material or workmanship.
Manufacturer can make substitutions as required of materials, components, and
sub-components of comparable value and utility. This warranty is limited to
product repair or replacement (to be determined solely by Manufacturer).
Warranty return is limited to only the single affected
component.
This warranty covers only manufacturing defects and does not cover normal wear
and tear, abuse or misuse, including: water damage, chemical damage, exposure
to extreme heat or cold or abrasion. This warranty is invalid if the product
is not used for intended
purpose. Manufacturer disclaims liability for any aspect of installation and
any inconvenience caused by a defective part of a component.
Certain items are not covered by this warranty. These include, but are not
limited to the following:
- Components subjected to abuse, including abuse intended to simulate failure.
- Damages caused by retailer, shipper or installation crew (such as scratches, dents, tears, breaks, etc.).
- Any part which merely exhibits normal wear yet functions essentially as new.
To make a claim, send a copy of the original sales receipt along with a brief
description of the problem to the email address below.
Please include your email address and daytime telephone or cell phone #. All
items will be charged actual freight costs plus $15 for handling. Repairs or
replacement will be made at the Manufacturer’s option.
THIS IS THE ENTIRE EXCLUSIVE EXPRESS LIMITED LIABILITY. THE MANUFACTURER
NEITHER MAKES NOR IS RESPONSIBLE FOR ANY OTHER WARRANTIES, EITHER EXPRESS OR
IMPLIED, INCLUDING THOSE OF RETAILING DEALERS. THIS EXCLUSIVE REMEDY IS
LIMITED TO RECEIPT OF A CREDIT IN CONNECTION WITH THE REPAIR OR REPLACEMENT OF
ANY PRODUCT OR COMPONENT DEEMED TO BE DEFECTIVE UNDER THE TERMS AND CONDITIONS
AS STATED IN THIS WARRANTY. NEITHER AF LIGHTING, THE PRODUCT MANUFACTURER NOR
ITS AGENTS SHALL BE LIABLE IN ANY CASE FOR INCIDENTAL, INDIRECT, SPECIAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF
ANY BREACH OF THIS WARRANTY OR NEGLIGENCE EVEN IF IT HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES. EXCEPT AS OTHERWISE MAY BE REQUIRED BY LAW, THERE
ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES OTHER THAN THE WARRANTY DESCRIBED
HEREIN, AND ALL OTHER WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY DISCLAIMED.
Contact Warranty Services at:
1-877-397-5144 or
contactus@hanover-products.com
12/1/2021
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>