Sinoxone SOB0115 TV Wall Bracket Black Instructions
- June 12, 2024
- SINOXONE
Table of Contents
SOB0115 TV Wall Bracket
Black Instructions
Instructions of SOB0115 Wall Fixed Installation for Panel TV
Technical parameter
Size of flat panel TV: 23″-55″ ; Maximum load: 50 ke ;
Distance from wall: 20mm .
Part List
Please check the parts in the package in comparison with the following list.
Make sure all of the parts are in the package. Never use defective parts.
Never replace part with different specification.
Installation and operation instructions
Step 1: Use the wall dead plate as a templet to drill four holes of 08mm
diameter and 50mm depth. The center distance of these holes is as the outboard
four holes in the wall dead plate. The four holes should be symmetrical in
horizontal and vertical directions. Insert four plastic concrete anchors into
the holes.
Step 2: Screw four lag bolts into the
plastic concrete anchors through washer and the wall dead plate to make the
dead plate and vertical wall into a whole.
Step 3: Select the installation place for the TV fixed plate and the
suitable screws according to the thread holes at the back of TV. Screw four
suitable screws to the thread holes at the TV back through the corresponding
holes in TV fixed plate. And the screws should be screwed down. The TV fixed
plate should be installed symmetrically and evenly on the TV back.
Step 4: Inserto the flanges of the TV fixed plate in connection with the
flat panel TV into the slots inboard of the wall dead plate. Don’t loosen your
hands until installed firmly.
Step 5: Screw two screws into the thread holes underside of the TV fixed
plate through the wall dead plate and screw up to make the wall plate and TV
plate in a whole. 
Sinox Europe A/S Troensevej 11.
DK-9220 Aalborg.
www.sinox-europe.com