ALLPOWERS AP-SP-027 Foldable Solar Charger User Manual
- June 12, 2024
- ALLPOWERS
Table of Contents
AP-SP-027 Foldable Solar Charger
User Manual
SP027 V2.0
AP-SP-027
AP-SP-027 Foldable Solar Charger
User Manual
The foldable and portable solar panel which is made for charging the most
portable solar generators on the market.The efficient solar cells belongs to
physical batteries which is recyclable,different from chemistry ones which
have a limited cycle life because of the lamination of battery material
itself.
Specifications
Peak Power: 100W±5%
Open Circuit Voltage (Voc) : 22.4V
Short Circuit Current (loc) : 6.0A
Maximum Power Voltage (Vmp) : 18V
Maximum Power Current (Imp) : 5.4A
Solar energy conversion rate: 19%-22%
Operating Temperature: -20°C^-60°C
All technical data at standard test condition(STC: E=1000W/m2 TC=25TAM=1.5)
Unfolded Size: 122x65x1cm±0.5cm/48×25.6×0.4inch±0.2inch
Folded Size: 51cx65x3cm±0.5cm120*25.6×1.2inch±0.2inch
Net Weight: 3.6KG±0.3KG/127.0±10oz
How it works
1.Place your solar panel to an area where you can get the most possible sunlight and adjust the angel to sun.
- All solar panels must be exposed to direct sunlight, avoid any possible shelters like buildings and trees .
- Solar panels angled at 30- 60 degrees from a flat surface will harvest the solar energy that is most possible.
- If your panels must be adhere to other surface. you need to avoid the damp or irregular surface as they might bring a bit distortion after long time sunlight exposure.(we can rescue it after a second long time exposure. )
- Please choose the sunny hours in a day(9:00 am to 5:00 pm)and panels operate at peak efficiency when the sun is most direct- typically around mid-day(am 12:00-1:00 pm)
2.Bulid connection between the solar panel and your Laptops/solar
generators.
- Solar panels generate electricity when panels meet sunlight, so please protect them with clothes before you plug in a device.
- Plug In the cable to the input of your device first, then the other end of cable go towards the output of solar case.
- Remove the clothes and you will find a charging sign on your laptop, if not, please build the connection again or replace another charging cable.
- II there shows up a charging sign, you can settle your device to a cool place for better heat dissipation and turn off your device to save the loss of energy during Its running hours especially for laptops.
3.How to chain multiple solar modules together
It is also designed for charging 12V/24V lead-acid batteries, including
lithium and other equipment, pis do pair the charging with a solar regulator
to protect the batteries system from overcharging.
-
You can add more solar panels together with MC4 Y connectors to get different output: voltages are additive when Panels are connected directly in series. and the currents are additive when panels are connected directly in parallel.
-
Only solar panel with similar electrical output should be connected in the same string to avoid mismatch effects.
-
How to build the series or parallel connection
The solar panel is equipped with two stranded, PV-rated, output MC4 cables. Wire range: 1 x 4mm2)
The Positive connector is a male connector and the negative connector is a female connector, these wires by themselves are rated for series connections, but could be adapted to hold parallel connections with an extra MC4 branch Y connectors. Mc4 connectors(Positive to Negative, Positive to Negative) -
Solar panels are connected in series (+ to – to +): the voltage is added, the power is added, and the current is unchanged.
-
Parallel connection of solar panels (+ to +, – to -): the voltage does not change, the power is added, and the current increases.
When the panels are connected in series, the voltage will increase, and when
the panels are connected in parallel, the current will increase.
Therefore, if three solar panels are connected in series at the same time, the
voltage may exceed the safe voltage of 501./. Please use them sparingly.
Series Connection
Parallel Connection
MC4 connectors
- Keep connectors dry and clean, and ensure that connector caps are hand tight before connecting the panel.
- Do not attempt making an electrical connection with wet, soiled, or otherwise faulty connectors.
- To better preserve its service life, please avoid sunlight exposure and water immersion of the connectors, and avoid connectors resting on the ground or roof surface.
- Faulty connections can result in electrical shock. Please check that all electrical connections at least once every 6 months. Make sure that all locking connectors are fully fastened and locked.
Warm Tips
- Please do not try to modify the PCB circuit inside the back junction box unless you are a professional technician, or we are not responsible for such a result.
- The solar panel charger is built with a anti-flow resistant preventer inside, it will not occur the backflow phenomenon.
- D0 not step, stand or jump on the surface of the solar panel. Heavy or sharp objects may scratch the solar panel and cause small cracks, affecting the output power or scratching the human body.
- If the solar panel is broken, please stop using it and contact professional maintenance personnel or the manufacturer’s after-sales service mailbox. A professional will fix it rather than fix it yourself.
- The waterproof coefficient of the solar panel is IP66, which is rainproof and can be immersed in water for a short time, but it is forbidden to immerse in water for a long time. Once it is short-circuited due to water immersion, please stop using it and contacting the seller.
Maintenance:
- The solar panel is mainly for emergency charging purpose, we do not suggest a long time outdoor exposure as it may shorten the lifespan of this product.
- Not bendable, please handle the solar panel with care, and avoid hitting it with sharp objects or knocking heavily on it.
- 1f your solar panel must be adhere to other surface, you need to avoid the damp or irregular surface as they might bring a bit distortion after long time sunlight exposure.(we can rescue it after a second long time exposure. )
- 1t is normal that solar panels got hotter during working hours and please store them with the box after they become cool down.
- Dirt and dust can accumulate on the surface over time, this can cause a general decrease of power output, we recommends periodic cleaning for panel with a mild, non-abrasive cleaning agent.
Disposal Guide
If circumstances permit, ensure that the product is disposed of in a designated recycling bin. Please follow local laws for more details.
Contact Us
Installing solar PV system may require specialized skills and knowledge. Otherwise, it is suggested to have it designed or inquired with an qualified installer. Besides, we have 18 months warranty on our products (from the date of its original purchase), if you have any questions or problems concerning your solar system, please email us at support@allpowers.com, we will offer help within 1 business day! Website: www.lallpowers.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>