MAJESTIC ARM2601 Double Swing ARM Lockable LED TV Wall Mount Bracket Instruction Manual

: June 12, 2024
: Majestic

Table of Contents

Technical parameter
Part List
Installation and operation instructions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Instructions of ARM2601 Wall Fixed Installation for Panel TV
Instruction Manual

Technical parameter

Size of flat panel TV: 13″~27″| Maximum load: 15 kg| Adjustable angle: up & down +15°
---|---|---
left & right +15°| Totation 360°| Distance from wall: 84~403mm

Part List

Please check the parts in the package in comparison with the following list. Make sure all of the parts are in the package. Never use defective parts. Never replace part with different specification.
Note: Incorrect installation may cause injury! MAJESTIC ARM2601 Double
Swing ARM Lockable LED TV Wall Mount Bracket - fig 1

Installation and operation instructions

Note: please read the instructions carefully before installation! MAJESTIC ARM2601 Double Swing ARM Lockable LED TV Wall Mount Bracket - fig
2 Mount wal plate on wall
For Brick, Concrete and Stone:
Using the wall plate s a template and using the leveler to easurethe wal plate i level. Mark 3 holes for the long bolts as picture. Pre-drill these holes with a ¢8mm bit to at least S0mm deep in the wall. Wall anchors(B) s inserted into the wall. Next mounting the wal plateto the wall using long bolt(A) and Long bolt washer (E). MAJESTIC ARM2601 Double Swing ARM Lockable LED TV Wall
Mount Bracket - fig 3 For Wood studs:
Using a stud finderto locate the one wood studs. Using the wallplte a5 a template, mark the 3 location fr the long bolt as picture and using th levele to ensure the wall plate is level. Pre-drll these holes with a §5mm bit o at least 50mm deep in the wall Next mounting the wall plat to the studs using the long bolt (A) and Long bolt washer (E). MAJESTIC ARM2601 Double Swing ARM
Lockable LED TV Wall Mount Bracket - fig 4 Install TV plate on the TV back. Select four suitable bolts from the parts bag and screw them into the bolt-holes in the back of the TV..The TV plate mounted on the TV back should be mounted symmetrically and everly.
Important-Do not use power tool to fit bracket to TV. Carefuly hand screw suitable bolts with screw driver. MAJESTIC ARM2601 Double Swing ARM Lockable
LED TV Wall Mount Bracket - fig 5 Lift the TV by two person, Insert the TV together with the TV plate into the wall plate, then lighten the knob firmly. Adjust the position and angle of the flat panel TV for convenient viewing. Using the inner hexagon spanner $=4 (L) toloosen the bolt before adjusting the view angle, and firmly tighten the bolt after adjustment While adjusting, please take care of your hand to avoid clipping. Route the cables along inside of the arm, the cables should be obligated some surplus in corner. With all cables in place, secure the cable covers in place. and pull the arm assembly in and out and check that the arm assembly moves freely. The cables surplus in corner can be adjusted by pullng the cables lghtly to keep lax and avoid stetching or damaging the cables. Thus the cables will be in protected status inside of the arm all along when adjusting the viewing angles of the display. (Shown as Fig ) MAJESTIC ARM2601 Double Swing ARM Lockable LED TV Wall Mount Bracket - fig
8 Please fasten the fixed nut as below procedure if the tilt angle cannot be fixed properly. Loosen the knob at first, then remove the TV together with the TV plate from the wall plate, Firmly tighten the fixed nut with a spanner in the clockwise direction. Insert the TV back to the wall plate, Tighten the knob to the TV plate tightly at last.