STROMBER CELSIUS Bathtub Instruction Manual

: June 12, 2024
: STROMBER

Table of Contents

Assembly & operating instruction
ASSEMBLY
Mounting instructions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

STROMBER CELSIUS Bathtub Instruction Manual

Assembly & operating instruction

Goggles are recommended to protect your eyes

Always use non-slip safety gloves.

Use safety shoes during installation

We recommend that two persons are present at the installation

There may be slight differences in measure- mints. Stromberg Bad will not accept any responsibility for drilling prior to measuring the relevant item. The stated measure- mints are only intended to help prepare any internal construction of the wall.

ASSEMBLY

DELTA

Mounting instructions

Before installation, please check that the bath has not been damaged in transport.
Place a piece of thick cardboard or similar material on the ground to prevent the bath being scratched and carefully place the bath upside down on this.
Fit the set of legs approx. 150-200 mm in from each end of the bathtub. Use the included 19 mm screws. PLEASE NOTE that the 28 mm bot- tom sheet is covered by fibre glass (see fig. C). If the bathtub is reinfor- ced with Carronite™ a Ø2 mm drill should be used to pre-drill. Adjust the legs to the desired height (see fig. C1). If the bathtub is being instal- led with front or L-panel the holding clamps should be fixed now (see fig. D and G.). Also fit the holding bars with the magnetic end plugs (see fig. C). Turn the bathtub around on its feet.
Determine the height at which the bath should be installed, bearing in mind the height of any side or end panels (if these are to be installed). Draw a horizontal line on the wall at the required height (fig. A). Please note that this line should mark the height of the underside of the bath lip (fig. B).
Mount the three wall brackets as shown in fig. A and B. An installation kit containing the wall brackets is included. 6) Remove the front and/or the end panels and carefully lift the bathtub up on the wall mount. Adjust the feet so they are resting solidly on the floor. It is very important the entire weight of the water filled bathtub is supported by the feet and not by the top edge of the bathtub. Make sure the tub is correctly placed and is levelled and then tighten the locking nut on each leg. Attach the front or L-panel and adjust the holding bars with the magnetic end plugs so the covers are positioned vertically (see fig. G1). Wall mount included for further support.
Connect the bath to the drain. Fill the bath with water and check that all the drainage connections are watertight (see fig F).
Let the water out before installing the panels or building the surround for the bath.
If the bath is to be built in, this should be done now. Remember the access panel so that the drain can be reached in case of blockages. If the bath is being installed with panels, these should be mounted now (see fig. G).
Remove the remaining protective film from the bath, fill the bath with water and seal around the bath with silicone as required. Leave the water in the bath for 24 hours so that the silicone can harden (see fig. I).
Let the water out of the bath and if the bath has been built in, seal the joints on the front and end of the bath with silicone.

GUARANTEE
A strict quality control ensures that the products that end up in your home are of an excellent quality. There is a 10 year guaran- tee on all standard bathtub, 30 year warranty on all Lucite® and CarroniteTM bathtubs, provided that the installation has been done by professionals and in accordance with the manufacturer’s instal- lation instructions.

CARE ADVICE
We recommend weekly cleaning with detergents intended for bathrooms. Use a soft cloth and avoid the use of eg scouring pads as this can scratch the product. Water and soap residue wipe off immediately.

Avoid: Detergent with scrubbing effect or containing solvents!
Example: Acids, bleach, caustic soda and ammonia (ammonia) must not be used!

According to EN60335 it is stated that:
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

In accordance with