KEITHLEY 2306-LAN Battery Simulating DC Power Supply Owner’s Manual
- June 4, 2024
- KEITHLEY
Table of Contents
Model 2306-LAN
Firmware Release Notes
Keithley Instruments
28775 Aurora Road
Cleveland, Ohio 44139
1-800-833-9200
tek.com/keithley
OVERVIEW
Version D04 is the initial firmware release for the Model 2306-LAN.
NOTE
Use this procedure only for the 2306-LAN.
Do not use this configuration procedure for the Series 2300 models 2302, 2303,
2306, or 2308.
Critical fixes
N/A
Enhancements
N/A
Noncritical fixes
N/A
Known issues
N/A
FIRMWARE UPGRADE INSTRUCTIONS
Download the 2306-LAN Configuration Tool from the Product Support and Downloads web page (tek.com/product- support). This tool provides the interface needed to upgrade the firmware and set up the 2306-LAN IP address, netmask, gateway, and port from a computer. Once the executable file for the configuration tool has been downloaded to your computer, follow the steps below to install and use the tool.
You will also need to download the firmware you want to install on your Model 2306-LAN instrument from the Product Support and Downloads web page (tek.com/product- support).
For LAN configuration information, see LAN configuration.
NOTE
Use this procedure only for the 2306-LAN.
Do not use this configuration procedure for the Series 2300 models 2302, 2303,
2306, or 2308.
Connect a LAN cable from your computer to the LAN port on the rear panel of the 2306-LAN. Set the computer IP address (192.168.0.3) and the Subnet mask (255.255.255.0), and set the instrument IP address (192.168.0.2).
To use the LAN Configuration Tool:
1. Double-click the 2306-LAN Configuration Tool.exe file.
2. Click Firmware Upgrade (see the following figure).
Figure 1: 2306-LAN Firmware Upgrade
3.
Select Local IP to your computer IP address (192.168.0.3) Refer to the
following figure.
4. Click Scan. The IP information of the instrument is displayed (the
default IP is 192.168.0.2).
5. Click Select Fw to choose the firmware file saved on your computer.
6. Click Fw Upgrade to proceed.
You will see the word “ SUCCESS ” when the upgrade is complete.
Figure 2: Upgrade LAN Firmware
PRODUCT SUPPORT
Contact product support (Product Support and Downloads web page (tek.com/product- support)) if you have any problems or questions. Alternatively, you can arrange to have Keithley Instruments upgrade your firmware at the factory by calling your local Keithley Instruments support office.
077174100 September 2021