hansgrohe 72806XXX Talis M54 U220 Kitchen Mixer Instruction Manual
- June 12, 2024
- hansgrohe
Table of Contents
hansgrohe 72806XXX Talis M54 U220 Kitchen Mixer Instruction Manual
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The hot and cold supplies must be of equal pressures.
Installation Instructions
- Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
- The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
- The plumbing codes applicable in the respective countries must be observed.
- 72805XXX, 72807XXX, 72827XXX: Only dishwashers and washing machines certified with the DVGW emblem may be connected to the appliance connection valve without an additional fuse. If no consumer is connected to the appliance connection valve, it must be plugged.
Technical Data
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 – 0,5 MPa
Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 60°C
Thermal disinfection: 70°C / 4 min
The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment
To adjust the hot water limiter. Using a hot water limiter in combination with
a continuous flow water heater is not recommended.
Dimensions
Flow diagram
Spare parts
XXX = Colors
000 = Chrome Plated
340 = Brushed Black Chrome
670 = Matt Black
800 = Stainless Steel Optic
Special accessories (order as an extra)
Adapter (G⅜ / G½) #93395000
Cleaning
Operation
Hansgrohe recommends not to use as drinking water the first half liter of
water drawn in the morning or after a prolonged period of non-use.
Test certificate
| Fault | Cause | Remedy |
|---|---|---|
| Mixer stiff | – Cartridge defective, calcified | Exchange cartridge |
| Mixer dripping | – Cartridge defective | – Exchange cartridge |
| Water escaping at the threaded base | – O-ring at the connection hose |
defective.
– connection hoses not completely screwed into basic body| Exchange O-ring
Hot water temperature too low| – Hot water limiter incorrectly set| – Set hot
water limiter
