EG4 Brightmount Adjustable Ground Mount System Installation Guide
- June 12, 2024
- Eg4
Table of Contents
EG4 BRIGHTMOUNT
ADJUSTABLE GROUND MOUNT SYSTEM
PARTS
DIMENSIONS AND LAYOUT
ENGINEERING DRAWINGS
LAYOUT AND INSTALLATION
OVERALL LAYOUT
Tools needed:
Torque Recommendations:
Bolt| Recommended
Torque| Bolt| Recommended
Torque| Bolt| Recommended
Torque
---|---|---|---|---|---
M8 bolt, M8 nut
| 115 in. lbs.
(13 Nm)| M10 bolt, M10 nut
| 140 in. lbs.
(25.8 Nm)| M8 bolt, N2 nut
| 97 in. lbs.
(11 Nm)
INSTALLATION
A) Leg Group Assembly
Use M8*80 bolts, M8 spring washers, flat washers, and M8 nuts to install the U
connectors as shown in the illustration to the right.
Use M8*65 bolts, M8 spring washers, flat washers, and M8 nuts to install the mount group as shown in the illustration to the left.
The adjustable leg is used to change
the angle of the array.
Adjustment instructions are on the following page.
Loosen set screws to adjust the angle of the array. Different angles
correspond to the lengths provided in the chart below. The recommended torque
for the set screws is 80 in. lbs. (9 Nm).
Note: Both set screws must be secured to lock the adjustable leg in
place.
Angle | 2S° | 30° | 35° | 40° | 45° |
---|---|---|---|---|---|
Length (L) | 21.8 in. | ||||
(55.4 cm) | 20.4 in. | ||||
(51.7 cm) | 18.9 in. | ||||
(48 cm) | 17.5 in. | ||||
(44.4 cm) | 16 in. |
(40.7 cm)
Use M8*80 bolts, M8 spring washers, flat washers, and M8 nuts to install L feet as shown in the illustrations to the right.
Use the provided anchor bolts to secure mounting brackets to the concrete anchors.
B) Rail Assembly
Follow the diagrams to secure the rails to the previously installed L feet. Use the splice connectors to join rail sections together, leaving a 0.1 0.2 in. (3 5 mm) expansion gap between rail joints.
Completed rail assembly.
PV ATTACHMENT
Install PV modules using the end clamps and mid clamps along with the
grounding clips to secure them to the mounting rails.
Follow the steps illustrated to the right for proper installation.
Install grounding lugs on the end of the rails to attach a grounding wire for proper array protection.
www.eg4electronics.com
Version 1.0.0 | Specifications subject to change without notice.
© 2023 EG4 Electronics, LLC. All rights reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>