MifiData MIFSPOTE5573S 4G Hotspot Wifi Router User Manual

MIFSPOTE5573S 4G Hotspot Wifi Router
User Manual

Manage your device

Using the Web Configuration utility
Change the network name（SSID）， the Security Mode and Key，configure the sleep modem and other settings.

1. Connect your Computer/Smartphone to device over USB or Wi-Fi interface.
2. Enter the URL: 192.168.8.1 in address bar of the browser to open the web configuration page
3. Click on Login button on the middle of web page screen by using “admin” as password to access the homepage of Web Configuration utility.

For fast support

A user connected access the internet
Please check if the user is connected to wifi SSID.
Make sure your battery sticker is removed.
Make sure your SIM card is properly inserted.
Check if your wifi is connected to the network
Ensure your sim card is activated and has adequate data balance avaiable.
4G Wifi Router how to set your device through the web configuration page

1. Know your Wifi.
   The signal light on the left, battery light on the right.
   If the battery light flashes red, it means your machine needs to be charged.
   If the signal light flashes green after inserting the card, it means the machine is in normal use.
   If red, you need to check whether the data of the SIM card is sufficient, or whether the SIM card is inserted in the correct position.

2. How to change SSID name and password.

3. How to know bands

4. How to choose the band you want

5. How to choose 4G only —— Network Settings
   A. Keep data disconnectedB. Choose the Network Settings

6. How to set APN
   A. First keep the data disconnectedB. Then choose setting, find sim card carrier APN and then fill in.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harm full interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Specific Absorption Rate (SAR) information:
This Device meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement the SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: Device has also been tested against this SAR limit. This device was tested for typical body-worn operations with the back of the device kept 10mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain an 10mm separationdistance between the user’s body and the back of the device. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessoriesthat do not satisfy these requirements may not comply with FCC RF exposure requirements, andshould be avoided.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>