Sportime Turnierkicker Guardian LED Instruction Manual

June 12, 2024
KICKER

Sportime Turnierkicker Guardian LED Instruction Manual
Turnierkicker Guardian LED

Congratulations! We hope you will have many hours to use your new soccer table and enjoy the pleasure it brings to you !

Please keep your instructions!

  • Your Model number is needed when you contact us.
  • Please read through this instruction book to familiarise yourself with all the parts and assembly steps.
  • Please find the attached tables for all the parts‘ name, specification and quantity.

Warning!

  • Please keep the balls,lubricant and other parts out of children’s reach.
  • Don‘t spray the lubricant to any person or animal.
  • This is not a child’s toy. Adult supervision is required for children playing this game.
  • please take care to avoid injuring any !hing or person when you push and pull the player rods .
  • Please read instructions carefully. Proper use of this set can avoid damage or injury.

ToolsTools required for assembly:

  • Slotted Head Screwdrivers, Power Driver
  • Roll Pin Punch), Allen Key

Parts list

Please note: There are 8 sets of Bearings (#9 & #23) have already been attached on the Table Body (#1). The pre-mounted version is fitted with handles, bushings, bumpers and soccermen.

Note: Before inserting the legs, remove the transport strips on the crossbars at both head ends of the soccer table.

Installation

CAUTION: Two strong adults are recommended to turn the table over as shown.

  1. Lift the table off the ground.
  2. Turn the table over.
  3. Place it on all four feet at the same time on the ground

Table Instruction
Table Information

  1. Hold Table
  2. Do not lean the table on its legs
  3. Do not hold the legs

FIG. 1: LEG ASSEMBLY

  • Attach the Legs (#2 & #3) between the Side and End Aprons with four Bolts (#11) per Leg as shown in Fig.1. Use the Allen Key (#19) provided.
    NOTE: Tighten the 3 leg screws (#20) only after all 3 screws have been mounted, this will prevent the table leg from twisting.

  • lnsert the Leg Levelers (#12) into the bottom of the Legs (#2 & #3), See Fig.1.

  • Lift the table assembled from the floor by two strong adults,turn it over, and set table on its legs in the location where you will play

Installation Instruction

Important: each team must be mounted with the head upwards and facing the opponent‘s goal

FIG. 2: PLAYER / BEARING / SCORER ASSEMBLY (Pre-mounted Version)

  • Carefully slide the grip end of Player Rod (#6) through the inside of Side Apron to outside (until the Player touch the Side Apron), then slide another end of the Player Rod ( #6) through the directly opposite hole in the opposite Side Apron.
  • Slide the Player Rods (#5, #6, #7) bearing in the accessory kits to the Side Aprons as shown Bearing (#8) in Fig. 2.
  • Attach the Scorer Assemblies (#13) in the middle of each Top Slat Board using two Screws (#11) per Scorer. See Fig.2.
  • Mount both ball dispensing trays at the opening of the ball chute. Use two wood screws (#10) for each.

Table maintenance

Table surface
Keep your table covered. lf there is dust on the playfield or the aprons, use a vacuum or wipe with a clean, soft cloth to remove.Do not sit on the table and do not use the table outside.
Rods
Occasionally wipe the rods with a clean, soft cloth. Never lift the table by the rods. Do not spin or press the rods too aggressively, as this may cause damage. We recommend the use of lubricant to wipe the Player Rods and Bearings from the outside of the game so as not to drip onto the playfield (see Fig. 3).
Legs
Check that the leg bolts are light. When moving the table, lift table off of its legs and place it down squarely on the legs, do not drag the table.

Assembly Soccermen („Kit“- Version)

  1. Mount the handles (no. 8) on the rods (no. 5,6,7). This works best if you first push the handles lightly onto the ends of the rods (the end of the rod is the side without the end cap). Then lightly knock the handles onto the floor (use a pad to avoid damaging the floor and the handles).
  2. Now mount the slide bearings (no.21) on the corpus. Do not overtighten the plastic screws to damage the inside of the bearings. A suitable TORX-25 (no. 22) bit is included in the set.
  3. Now slide in the play rods as shown in fig.4
  4. mount the figures (No. 18), bumpers No. 15) and bushings (No. 14) on the rods (see fig. 4). make sure that the figures are playing in the correct direction.

Player Installation

Game rules

  1. To start play, flip a coin to see which team or player will serve first. To begin, serve the ball in the middle of the playfield.
  2. Pass and score by pushing and pulling rods and twisling grips. Spinning the rods is considered illegal in tournament play. lf playing as teams (more than two players total), once the ball is served, players may not change position on the rods until: one team scores; a team requests a limeout (maximum 2 per game); the ball must be served again; or between games.
  3. A point is scored when the ball enters the goal. A serve, by the team last scored upon, follows each goal. Teams change table sides after each game.
  4. lntentionaljarring or tipping of table during play is illegal, and reaching into the playing area during play is illegal (except for a dead ball).
  5. A ball is considered a DEAD BALL when it has completely stopped its motion or is unreachable by any player. lf a ball stops between the goal and the two-manrod, then it is pul back into play by placing it in the corner !hat is nearest the dead ball spot. lf the ball completely stops anywhere eise on the playfield between both two–manrods, it is pul back into play with a serve by the team that originally served the ball.
  6. lf a ball leaves the playing area during play (other than through the goals), the ball is considered OUT OF PLAY. The ball is returned to play with a serve by the team which originally served the ball.
  7. This game is meant to be played with either two of four players. We recommend that all others should stand clear of the Table Playing Area if they are not playing.
    NOTE: The Game Rules have a little difference according to different Tournaments.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals