ZGO ZL2 Dual Monitor Arm with Sliders Instruction Manual
- June 12, 2024
- zgo
Table of Contents
ZGO ZL2 Dual Monitor Arm with Sliders
IMPORTANT: Failure to read, thoroughly understand, and follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty.
INSTRUCTIONS OF SAFETY AND WARNINGS
- Make sure that the mounting surface is strong enough to handle a mounted product and equipment.
- DO NOT EXCEED THE MAXIMUM LISTED WEIGHT CAPACITY.
- Always use an assistant or a mechanical lifting device to safely lift and position heavy products.
- Tighten screws firmly, but do not over-tighten. Over-tightening can cause product damage that greatly reduces the holding power.
- Keep a clear area and distance Use only as intended. Never stand, or hang from moving in a parts w when using the product. This product is intended for indoor use only. the product.
- Any attempts to reconstruct the construction aren’t allowed. This product may contain small items that could be a choking hazard if swallowed.
- Keep children away unless the product is intended for their use and all instructions and manuals are fully reviewed and understood by them.
- Check that the product is secure and safe to use at regular intervals (at least months). every three Should you ever have any questions or feel you require help please get in touch with your place of purchase for assistance.
NOTE: Should you ever have any questions or feel you require help please get in touch with your place of purchase for assistance
MODEL
VESA Compatible 75×75 100×100
REQUIRED TOOLS
INSTALLATION
To
properly balance the arm with monitors mounted, adjust the spring tension
using the supplied Allen Key as follows:
- First, position and firmly hold the arm horizontally as shown. Ask for assistance should you require it.
- CAUTION: To avoid damage to monitors or mounts, always keep the arm in a horizontal position while making adjustments. Again, ask for assistance if required.
- If the arm drops, turn the adjustment screw clockwise until it stays in a horizontal position.
- If the arm rises, tug the adjustment screw counter-clockwise until it stays in a horizontal position.
- CAUTION: DO NOT over-tighten the screws.
- CAUTION: DO NOT rotate monitor arms rear edge of desk to avoid an unstable situation may cause tipping.
- Note: If the display does not stop at your desired position, tighten the screw as shown.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>