HANOVER HARIAGLD-1WS Aria Gold Single-Light Wall Sconce User Guide
- June 12, 2024
- HANOVER
Table of Contents
HANOVER HARIAGLD-1WS Aria Gold Single-Light Wall Sconce
Product Information
The model number of your lighting is printed on the side of your carton.
Always use this number to identify your lighting.
Thank you for your purchase of this quality lighting. With proper use and
care, your lighting will provide you with years of use. Please follow the
instructions on how to install your lighting. If you should have any problems
with your lighting DO NOT return it to the place of purchase. Please call our
toll free number: 877-397-5144 and a
customer service representative will assist you.
Please read all instructions completely before installing your lighting.
NOTE: It is recommended to contact a licensed electrical contractor for
hardwire installation.
WARNING: To reduce the risk of fire, electric shock, or personal injury:
- Turn off /unplug lamp and allow to cool before replacing bulb.
- Do not touch bulb when fixture is turned on.
- Do not look directly at lighted bulb.
- Keep materials that burn easily away from lighted bulb.
CLEANING: Use only soft cloth to dust and clean fixture. Never use
chemicals or abrasive cleaners as it may damage finish.
Item No: HARIAGLD-1WS
WARNING: To avoid risk of electrical shock, be sure to shut off power
while installing or servicing this fixture.
- Carefully unpack and take out the parts as in drawing below.
- Thread mounting screws (A) into the match holes of universal mounting plate (B).
- Secure universal mounting plate (B) to outlet box with outlet box screws (D). OUTLET BOX NOT INCLUDED
- Pull out the outlet wire and ground wire from the outlet box (M). Make wire connections (I).
- White wire (w/o marking) from light to White wire (J) from power source.
- Black wire (w/o marking) from light to Black wire (L) from power source.
- Loop the ground wire (K) to universal mounting plate (B) with a ground screw (C).
- After wires are connected, tuck them carefully inside outlet box. Raise face plate (E) allowing for the mounting screws (A) to protrude through the hole on face plate (E), then secure with cylinder nuts (F).
- Place the fabric shade (H) over the socket (G).
- Install the bulb into the socket. BULB(S) NOT INCLUDED
1-Year Limited Warranty
For a period of one (1) year after purchase, Hanover Products (Manufacturer)
will either repair or replace defective components in accordance with this
Limited Warranty. This warranty covers only manufacturing defects and does not
cover normal wear and tear, abuse or misuse, including: water damage, chemical
damage, exposure to extreme heat or cold or abrasion. This warranty is invalid
if the product is not used for intended purpose. Manufacturer disclaims
liability for any aspect of installation and any inconvenience caused by a
defective part of a component.
Sales and use taxes, plus shipping and handling charges are the responsibility
of the consumer.
This warranty is between Manufacturer and the original purchaser and is valid
only when accompanied by the original purchaser’s sales receipt showing
original date of purchase and location of purchase. Replacements under this
warranty revert back to the date of original purchase for future warranty.
Manufacturer or its authorized dealer can accept or reject warranty claims
based on its findings. This warranty applies in normal residential use only,
where an issue with the product is due to a defect in material or workmanship.
Manufacturer can make substitutions as required of materials, components, and
sub-components of comparable value and utility. This warranty is limited to
product repair or replacement (to be determined solely by Manufacturer).
Warranty return is limited to only the single affected component. This
warranty covers only manufacturing defects and does not cover normal wear and
tear, abuse or misuse, including: water damage, chemical damage, exposure to
extreme heat or cold or abrasion. This warranty is invalid if the product is
not used for intended purpose. Manufacturer disclaims liability for any aspect
of installation and any inconvenience caused by a defective part of a
component.
Certain items are not covered by this warranty. These include, but are not
limited to the following:
- Components subjected to abuse, including abuse intended to simulate failure.
- Damages caused by retailer, shipper or installation crew (such as scratches, dents, tears, breaks, etc.).
- Any part which merely exhibits normal wear yet functions essentially as new.
To make a claim, send a copy of the original sales receipt along with a brief
description of the problem to the email address below. Please include your
email address and daytime telephone or cell phone #. All items will be charged
actual freight costs plus $15 for handling. Repairs or replacement will be
made at the Manufacturer’s option.
THIS IS THE ENTIRE EXCLUSIVE EXPRESS LIMITED LIABILITY. THE MANUFACTURER
NEITHER MAKES NOR IS RESPONSIBLE FOR ANY OTHER WARRANTIES, EITHER EXPRESS OR
IMPLIED, INCLUDING THOSE OF RETAILING DEALERS. THIS EXCLUSIVE REMEDY IS
LIMITED TO RECEIPT OF A CREDIT IN CONNECTION WITH THE REPAIR OR REPLACEMENT OF
ANY PRODUCT OR COMPONENT DEEMED TO BE DEFECTIVE UNDER THE TERMS AND CONDITIONS
AS STATED IN THIS WARRANTY. NEITHER AF LIGHTING, THE PRODUCT MANUFACTURER NOR
ITS AGENTS SHALL BE LIABLE IN ANY CASE FOR INCIDENTAL, INDIRECT, SPECIAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF
ANY BREACH OF THIS WARRANTY OR NEGLIGENCE EVEN IF IT HAS BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES. EXCEPT AS OTHERWISE MAY BE REQUIRED BY LAW, THERE
ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES OTHER THAN THE WARRANTY DESCRIBED
HEREIN, AND ALL OTHER WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE EXPRESSLY DISCLAIMED.
Product Usage Instructions
- Carefully unpack and take out the parts as in drawing below.
- Thread mounting screws (A) into the match holes of universal mounting plate (B).
- Secure universal mounting plate (B) to outlet box with outlet box screws (D). OUTLET BOX NOT INCLUDED.
- Pull out the outlet wire and ground wire from the outlet box (M). Make wire connections following local electrical codes.
Note: 120V/60W
Contact Warranty Services at:
1-877-397-5144
or
contactus@hanover-products.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>