HENNEPIN MADE Parallel Orb Sphere Pendant Lamp Instruction Manual

HENNEPIN MADE Parallel Orb Sphere Pendant Lamp

Product Information

The product is the Parallel Orb pendant light. It includes the following components:

• (A) Lever Nut – 2 pieces
• (B) Crossbar Assembly – 1 piece
• Includes: Bushing, Crossbar, Ground Screw, Nipple, Hex Nut
• (C) J-Box Screws – 2 pieces
• (D) Canopy – 1 piece
• (E) Strain Relief – 1 piece
• (F) Orb Pendant – 1 piece

Please note that the J-Box is not included and should be obtained separately. It is important to consult a licensed electrician before installation to ensure correct installation and to avoid voiding the warranty.

DANGER:
ELECTRIC SHOCK RISK. Always turn off electrical power before beginning the installation process.

Product Usage Instructions

1. Thread the pendant cord through the Strain Relief (E), Canopy (D), and Crossbar Assembly (B) in that order. Take care not to snag the cord on these items. Adjust the cord length by tying a safety knot as shown. If the cord is too long, cut it to the desired length and strip the outer jacket and individual wires. Loosely coil any extra cord inside the J-Box.
2. Securely fasten the Crossbar Assembly (B) to the J-Box using the J-Box Screws (C).
3. Using the Lever Nuts (A), connect the pendant wires to the 120VAC power. If there is a Ground Wire present in the J-Box, attach it to the Crossbar Assembly (B) using the green Ground Screw.
4. Slide the Canopy (D) and Strain Relief (E) up to the Crossbar Assembly (B) without snagging the cord. Thread the Strain Relief onto the remaining length of the threaded nipple until the Canopy is flush to the ceiling and the Strain Relief is finger-tight. If the threaded nipple is too long, loosen the hex nut and thread the nipple further up into the Crossbar Assembly, then tighten the hex nut.
5. Push the pendant cord upward into the Canopy (D) slightly and tighten the set screw in the Strain Relief (E).
6. Finally, restore power to the circuit.

Overview

Please consult a licensed electrician before installation.
Incorrect installation or failure to follow care instructions will void warranty.

DANGER: ELECTRIC SHOCK RISK.
Turn off electrical power before beginning installation.

Installation

STEP 1
Thread pendant cord through Strain Relief (E), Canopy (D), and Crossbar Assembly (B) in that order. Be careful not to snag cord on these items. Set desired cord length by tying safety knot in cord as shown. If cord is too long, cut cord to desired length then strip outer jacket and individual wires. Loosely coil extra cord inside of J-Box.

STEP 2
Fasten Crossbar Assembly (B) to J-Box with J-Box Screws (C).

STEP 3
Using Lever Nuts (A), connect pendant wires to 120VAC power. If a Ground Wire is present in the J-Box, attach it to the Crossbar Assembly (B) using the green Ground Screw.

STEP 4
Slide Canopy (D) and Strain Relief (E) up to Crossbar Assembly (B) without snagging cord. Thread Strain Relief onto the remaining length of the threaded nipple until Canopy is flush with the ceiling and Strain Relief is finger- tight. If the threaded nipple is too long, loosen hex nut and thread the threaded nipple further up into Crossbar Assembly, tightening the hex nut after.

STEP 5
Push the pendant cord upward into Canopy (D) slightly and tighten the set screw in Strain Relief (E).

STEP 6
Return power to the circuit.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>