LED SOURCE Portable Projector User Guide
- June 12, 2024
- LED SOURCE
Table of Contents
SOURCE Portable Projector
User Guide
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
Important safety precautions
For best results, it is recommended that you use this unit in a dark room.
- Do not install it in places where water vapor or temperature is too high, which may lead to failure of the machine
- Ensure adequate ventilation, and the air outlet at the bottom is not blocked, so as not to accumulate heat in the machine
- to prevent foreign matters, such as paper scraps, paper clips, etc. from falling into the machine, do not insert any metal objects, such as wire screwdriver into the machine, do not place any liquid on the machine to avoid leakage, such as accidental occurrence, be sure to cut off the power supply immediately, and contact professional maintenance
- When carrying the projector, please use soft packaging. In order to protect the lens from being scratched, please try not to touch the lens
The bottom air outlet should not be placed on the soft surface, otherwise it will affect the overall heat dissipation performance of the machine
In order to maintain the performance and reliability of the projector, at
least 30CM of space should be left between the projection and the wall
The picture is for reference only
Important Safety Matters
focusing
Focus: when the image is blurred, adjust the focus ring on the fuselage to obtain a satisfactory image effect. If the resolution cannot be achieved through adjustment, please move the product forward and backward according to the circumstances.
Trapezoidal correction: when trapezoidal distortion occurs, the user needs to adjust the electronic trapezoidal correction in the Settings
**Understanding the Remote control
**
Safety
shutdown
The following steps can turn off the projector and store the equipment safely
Press the top of the projector Or on the remote control key
2 Retract the lens with a focus twist and store it safely
Installation
Projected range reference
The data are for reference only.
IOS is the trademark of Apple. (USA)
Window/VGA is the trademark of Microsoft (USA) .
Android is the trademark of Google (USA).
Every trademark in the USER’ S GUIDE is treat solemnly without special
notice.
Documents / Resources
| LED
SOURCE Portable
Projector
[pdf] User Guide
X8, 2A9CJ-X8, 2A9CJX8, Portable Projector, Projector
---|---