LUNAPRBATTUDY Battery Powered Ellipsodial LED User Manual

LUNAPRBATTUDY Battery Powered Ellipsodial LED User Manual

PRODUCT SPECIFICATIONS

PRODUCT SPECIFICATIONS

• Voltage: 24VDC
• Max Power: 10W
• Size: 341 130 133
• Weight: .7
• Charging: 5h
• Discharging: h at full output

SAFETY WARNING

IMPORTANT
ALWAYS READ THE USER MANUAL BEFORE OPERATION. PLEASE CONFIRM THAT THE POWER SUPPLY STATED ON THE PRODUCT IS THE SAME AS THE MAINS POWER SUPPLY IN YOUR AREA.

• This product must be installed by a qualified professional.
• Always operate the equipment as described in the user manual.
• A minimum distance of 0.5m must be maintained between the equipment and combustible surface.
• The product must always be placed in a well ventilated area.
• Always make sure that the equipment is installed securely.
• DO NOT stand close to the equipment and stare directly into the LED light source.
• Always disconnect the power supply before attempting maintenance.
• Always make sure that the supporting structure is solid and can support the combined weight of the products.
• The earth wire must always be connected to the ground.
• Do not touch the power cables if your hands are wet.

ATTENTION

• Do not operate in a sealed enclosure with insufficient air flow
• Do not operate in an environment with temperatures in excess of 45deg. C.
• Do not operate store in close proximity to source of fire.
• Always charge with supplied charger
• Do not charge for more than 24 hours
• Always turn off battery storage switch when storing for longer than 7 days
• Always store with full load
• Always charge with flightcase open
• Always carry out one full discharge and charge cycle every 3 months
• Always store in a dry environment away from direct sunlight

INSTALLATION

MOUNTING

HANGING

The fixture can be mounted in a hanging position using the supporting bracket. The bracket should be secured to the mounting truss or structure using a standard mounting clamp. Please note that when hanging the unit a safety cable should also be used.

UPRIGHT

The fixture can be mounted in an upright or sitting position using the supporting brackets.

NOTE

PLACE THE TRIPOD

HANGING FIXTURE FIRST, AND THEN FIX IT TO TRIPOD WITH M10 STAINLESS STEEL SCREWS, ANGLE IS ADJUSTABLE, SHOWED AS PICTURE 2.1-3

OPERATION

INSTRUCTION FOR SWITCH

1. Table for luminance
   Adjust luminance according to % on sticker

2. Warning light for power capacity Warning light: green power>55%, yellow power >33% red no power, warning light is on when fixture working and charging wheen off when charging finish

3. In-charging for battery

OPERATION FOR ZOOM AND FOCUS

INSTALLATION FOR GEL FRAME HOLDER AND GOBO HOLDER

INSERT GOBO HOLDER AND GEL FRAME HOLDER INTO THE GAP SHOWED AT ABOVE PICTUR

BATTERY CHARGING

FLIGHT CASE SPECIFICATIONS

Voltage: AC100-240V, 50,60Hz
Rated Power : 150W
Weight: 8.5KG
Dimensions: 672x412x129mm

PHYSICAL MAP FOR CHARGING SUITCASE

CHARGER SPECIFICATIONS WITH CARTONS

Voltage: AC100-240V, 50/60Hz
Output: DC24V, 1A
LED 200mA

THE FLIGHTCASE MUST HAVE THE HOOD OPEN WHEN CHARGING.

CHARGING SUITCASE

WITH TRIPOD SUITCASE

IMPORTANT FACTS:

HOW TO CARE FOR YOUR BATTERY!

CHARGING
DO NOTCHARGE FOR MORE THAN 24HRS RECHARGEWITHIN 3 DAYSOF USE CHARGE WITH FLIGHTCASEOPEN

STORING
STOREWITH FULL LOAD TURN OFF ATBASE WHEN STORINGFOR MORE THAN 7 DAYS STOREIN AN UPRIGHT POSITION

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>