ENDON 96905 Outdoor Wall Light Fitting Instruction Manual
- June 4, 2024
- ENDON
Table of Contents
ENDON 96905 Outdoor Wall Light Fitting
Safety Warnings
- These instructions are for your safety.
- Please read through them thoroughly before use and retain them for future reference. If you are in any doubt about installing this product, consult a qualified electrician.
- This product is only suitable for connection to a 220-240V~ 50Hz supply in accordance with current IEE wiring regulations and should be installed in accordance with local building regulations.
- This product is suitable for use outdoors but should not be immersed in water / sited in areas likely to be heavily splashed, either from above or below, or subjected to standing water.
- If being fitted in a bathroom, this product is suitable for bathroom outside zones as specified by the right diagram.
- The appliance must be supplied through a residual current device
- (RCD) having a rated residual operating current not exceeding 30mA.
- This product is rated IP44( definition e.g. splash proof / rain proof etc).
- Ensure that the screws and cable entry points are sealed to maintain the IP rating of the product.
This is a Class l product and must be Earthed. The terminal blocks are supplied according to requirements of the fitting.
IMPORTANT: Always switch off the mains supply during installation or maintenance. We recommend that the fuse is withdrawn or the circuit breaker switched off at the distribution board whilst work is in progress (turning off the light switch is not sufficient). Connection should be via a wall switch to enable safe isolation.
The product must be securely fixed to the mounting surface using the screws
and wall plugs supplied. The screws and wall plugs supplied are suitable for
“masonry” only. Other fixings are not supplied and must be purchased. Decide
on the position of the light fitting or remove existing light fitting. Note
the position of the electrical connections, and ensure there is a solid
mounting surface, Preferably a wooden joist or joist bridge, to support the
weight of the light fitting. Take care not to drill into any pipes or mains
cables beneath the surface during mounting holes preparation.
Never put anything on the product or hang anything on any part of this
product.
IMPORTANT : Ensure that all electrical connections are tight and that no
loose strands are left out of the terminal.
Never fit bulbs of a higher wattage than those specified on the label (as
these may cause over heating and damage the fitting).
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
local store for recycling advice.
Care and maintenance
For bulb replacement, switch off the product (preferably, isolate it at the distribution board) and allow it to cool down (Caution: bulb gets hot during use). Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
Troubleshooting
When the bulb does not light after installation:
- Ensure there is no electricity failure.
- Ensure all the connections are secure.
If you have any doubt about installation/use of this product, consult a qualified electrician.
Assembly Instructions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>