ILS S1839 Seat Walker Holder Installation Guide
- June 12, 2024
- ILS
Table of Contents
INDEPENDENT LIVING SPECIALISTS
Assembly Guide
Seat Walker Holder – Scooter Accessory
S1839 – Scooter Accessory – Seat Walker Holder for Scooters (ILS ADL)
S1839 Seat Walker Holder
Included in the Box
A. Metal pins
B. Screws
C. Hanging clips
D. Large T shaped bar
E. Small T shaped bar
F. Small extension bars
G. Large extension bar
H. L shaped ba
- Place L shaped bar in rear receiver of scooter and place metal pin and/or screw in position.
- Place the small T shaped bar through the L shaped bar.
- Slide the small T shaped bar to the very bottom of the L shaped bar and tighten screw into position.
- Place small extension bars at both ends of the T shaped bar and tighten with screws.
- Install long extension tube onto the top of the L shaped bar and fix into position with screw and metal pin.
- Place this T bar on top of the long extension tube and insert screw.
- Screw a hanging clip into position on the left and right side, facing outwards at the end of the small T shaped bar.
- See fully assembled seat walker holder.
- Lift and place seat walker on the holder via the backrest (models may vary, best to check prior to purchasing).
- Secure tightly to the holder with Velcro straps provided.
©2023 Independent Living Specialists, Unit 1, 12 Mars Road Lane Cove West NSW
2066
1300 008 267
ilsau.com.au
PDT030-0323
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>