LUPINE C14 MAG Tail Light for Bike Instruction Manual
- June 12, 2024
- LUPINE
Table of Contents
C14 MAG
Tail Light for Bike
Instruction Manual
C14 MAG Tail Light for Bike
Turn on
By default, the C14 MAG can be switched on by a double click. (Other settings,
see „Changing settings“).
Turn off
Keep button pressed for about 1-2 sec.
Charging
You can charge your C14 MAG with the enclosed magnetic charging cable.
Charge level indicator
During charging the status led on the button of the C14 MAG lights up. (Lights
red = charging, Lights green = fully charged)
Capacity indicator
After switching on, a status LED next to the button indicates the capacity:
100 – 51% capacity = lights green
50 – 26% capacity = lights red
25 – 0% capacity = continuously blinks red
-> C14 Mag has to be charged
Light sensor:
When the light sensor is activated, the C14 MAG turns on or off depending on
the ambient light. The C14 MAG must be switched on for this. When changing
from darkness to brightness the sensor controlled switch off takes place with
a delay of approx. 20 sec.
Brake sensor:
A sensor built into the rear light reacts with a brief signal to sudden
braking. (Hereafter referred to as the brake sensor) Afterwards it switches
back to the original light level.
Changing settings
Keep the button pressed until the desired setting (8 Sec.), then release the button immediately. The C14 MAG must be switched on for this.
| Lights up 1x | Double Click on / off |
|---|---|
| Lights up 2x | Lightsensor on / off |
| Lights up 3x | Brake sensor on / off |
| Lights up 4x | 0.3W mode |
| Lights up 5x | 0.5W mode |
| Lights up 6x | Reset to factory setting |
Italic = Factory setting
Assembly
Place the C14 MAG holder vertically on the seat post.
Now pull the band tightly around the seat post, then fasten it in the side
hook (for seat posts with a diameter of 27-40 mm). The holder must be firmly
attached to the seat post and its position must not be able to be changed. Now
slide the C14 Mag into the holder. The radiation must bealigned parallel to
the road.
Please make sure that no objects are covering the rear light, also it mustbe
aligned vertically. The permissible mounting height is 250 – 1200mm.
Technical Data:
LED: COB LED
Power: 0.3 – 0.75 W
Brake light: 0.75W
Battery: Li-Po 4.4Wh
Charging time: ca. 3h
Material: 6061-T6 aluminium anodized
Weight: 60g
Runtime: 22h max.
Protection class: IP68/ IK09
Approval: K 1660
More information at: www.lupine.de
EC Declaration of conformity:
www.lupine.de/ce/
Lupine lighting systems GmbH
Im Zwiesel 9
D – 92318 Neumarkt
Germany
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>