KUZMA STABI R Wood Frame Turntable Instruction Manual

: June 12, 2024
: KUZMA

Table of Contents

KUZMA STABI R Wood Frame Turntable
General
Technical data
Preparing Stabi R for plinth fitting
Assembling
Tonearm mounting
Maintenance
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KUZMA STABI R Wood Frame Turntable

KUZMA-STABI-R-Wood-Frame-Turntable-product-img

General

Stabi R wooden frame-plinth is made from solid walnut and plywood into which you can fit the Stabi R base turntable. The arm board block is supplied with the Kuzma 9-inch arm cut.
The Stabi R plinth is supported on three fully adjustable metal feet.
For more details read the instruction manual for the Stabi R wood turntable and check the plinth dimensions which are both available on our website.

Technical data

Mass: 9 kg
Plinth: walnut( oil protected)
Leveling: yes (3 adjustable feet)
Armboard: yes ( arm board block)
No. of tonearms: 1
Dimensions: 500 x 463 x 113 mm
Accessories supplied: Torx bit T30, screws 3 x M6x40, 2x wooden screws

Basic Setup
Note: Some parts are heavy, so be careful when handling them!
Note: Choose a suitable supporting table that can hold over 40 kg without warping.

Unpacking
The plinth is packed in one box. Before unpacking prepare the area where the assembly will take place. The best position is on a solid table that is strong and rigid enough to support 40-50 kg.

Preparing Stabi R for plinth fitting

Depending on which version of the turntable you have, remove all parts from the base: platter, belt, sub platter, tonearm, arming, arm holders, arm balconies, supporting spikes, side panels, un plug cable and it is best to remove the bearing shaft with oil reservoir by removing 3 screws using Allen key 3 mm. See Fig. 1.&2.

KUZMA-STABI-R-Wood-Frame-Turntable-fig-1

Assembling

Place the sheet of white foam from the packing box on the table.
Place Stabi R base with the top down. See Fig. 2.
Over Stabi R base put the plinth face down over the base. See Fig. 3.
Check the alignment of holes and manually fit three fixing screws M 6×40 and secure them by using the Allen key 5mm. See Fig. 3.
Turn the whole assembly turn back and remove the foam. Be careful-it is heavy. See Fig. 4.
Position the turntable over the edge of the table to fix armboard block. Fix 2 wooden screws into the arm board block. See Fig. 5.
Then return the bearing shaft with reservoir and assemble the turntable.

KUZMA-STABI-R-Wood-Frame-Turntable-fig-2

Tonearm mounting

Mount the arm as instructed in the tonearm instruction manual.
The arm board block is fixed in the plinth. Under the arm cutout is hole with access underneath to fix the armbase.
If required route the tonearm cable underneath.