SUNCO LIGHTING HB08 UFO LED High Bay Instruction Manual
- June 12, 2024
- Sunco Lighting
Table of Contents
SUNCO LIGHTING HB08 UFO LED High Bay
High Bay – HB08 Installation Guide
The High Bay – HB08 is a lighting fixture that can be installed using different methods, including hook installation, trunnion installation, and emergency power installation. The following are the installation instructions:
Hook Installation
- Tighten the hook into the 3/4 NPS screw hole of the fixture.
- Tighten the PM4x6 screw beside the hook.
- Connect the wire according to the wiring diagram.
- Installation is done.
Note: The PM4x30 Screw and Hook are required for this installation method.
Trunnion Installation (Optional)
- Secure the fixture to the mounting position, then adjust the desired angle and lock the angle adjustment screw.
- Connect the wire according to the wiring diagram.
- Installation is done.
Note: The PM4x6 Screw is required for this installation method.
Emergency Power Installation (Optional)
- Hang up the safety rope firstly, tighten the hook into the 3/4-14NPS hole of the fixture.
- Tighten the PM4x6 screw beside the hook.
- Connect the wire according to the wiring diagram.
- Installation is done.
Note: The PM4x6 Screw and Accessory pocket are required for this installation method.
WARNING
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION3
- To prevent personal injury or product damage only licensed electricians should install.
- To avoid electric shock or component damage disconnect power before attempting installation or servicing.
- This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric codes and safety standards.
- Disconnect product and allow cooling prior to servicing.
- Any alteration or modification of this product is expressly forbidden as ii may cause serious personal injury, death, property damage and/or product malfunction.
- To prevent product malfunction and/or electrical shock this product must be properly grounded.
- This luminaire is designed to operate in ambient temperatures ranging from -40°F to 122°F and to be horizontally mounted with the LEDs facing down.
- This product must be installed in accordance with the applicable installation code by a Person familiar with the construction and operation of the product and the hazards involved.
- Min 167°F supply conductors.
- This product is not available for several special environments, such as places with corrosive gas liquids or high pressure water vapor.
Installation instructions
Hook installation
- Tighten the hook into the 3/4 NPS screw hole of the fixture.
- Tighten the PM4x6 screw beside the hook.
- Connecting the wire according to the wiring diagram then installation is done.
Trunnion installation (Optional)
- Secure the fixture to the mounting position, then adjust the desired angle, lock the angle adjustment screw.
- Connecting the wire according to the wiring diagram then installation is done.
With emergency power installation (Optional)
- Hang up the safety rope firstly, tighten the hook into the 3/4-14NPS hole of the fixture.
- Tighten the PM4x6 screw beside the hook.
- Connecting the wire according to the wiring diagram then installation is done.
Power and CCT Selectable Version
-
Open the silicone plug of the fixture, select the appropriate power and color temperature in the actual application of the sliding dip switch, then install the silicone plug back.
As shown in the following figure:
-
When installing the sensor, remove the screw plug of the fixture, insert the sensor and tighten it clockwise, as shown in the following figure:
Note: When the emergency function and sensor are used at the same time, the Sensor’s ‘ : stand-by time is less than 90 minutes, the sensor’s stand-by time prevails, if you need to : prepare for the emergency 90 minutes, you need to set the sensor’s stand-by time to more : : than 90 minutes. ‘
Wire Connection
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>