Pomona 5056 Triaxial Male 2 Lug Connector to Cable Instruction Manual
- June 12, 2024
- Pomona
Table of Contents
Technical
Data Sheet
Model 5056 & Assembly Instructions
Triaxial Male 2 Lug Connector to Cable
Model 5056
Triaxial Male 2 Lug Connector to Cable
Features
- Fits Belden 9222 triaxial cable, 0.242″ O.D.
Materials
Body and Fittings: Brass, Tarnish Resistant Plating
Center Contacts: Male: Brass, Gold Plated
Outer Contact: Beryllium Copper, Gold Plated
Dielectric: PTFE
Specifications
Voltage: 500 Vrms
Impedance: 50 Ohm
Temperature: -65° C. (-85° F.) to +165° C. (+329° F.)
Frequency Range: DC to 500 MHz
Ordering Information
Model: 5056
Triaxial Male 2 Lug Connector for Belden 9222 Cable
- CLAMP NUT
- BRAID CLAMP
- CENTER CONTACT
- OUTER CONTACT
- BODY
- INNER INSULATOR A
- INNER INSULATOR B
- INSULATOR
FIGURE #1
1.1 Strip cable per drawing lengths (mm).
1.2 Slide nut onto stripped cable.
1.3 Insert braid clamp and insulation on stripped cable.
FIGURE #2
2.1 Solder pin with center conductor then insert inner insulator A and B on
the pin.
2.2 Peel back shield and insert outer contact.
FIGURE #3
- SOLDER POINT
3.1 Position shield on solder point and solder outer contact to shield.
3.2 Insert body on assembled cable and fasten with wrench.
FIGURE #4
4.1 Completed assembly shown.
USA:
Sales: 800-490-2361
Technical Support:
technicalsupport@pomonatest.com
Fax: 425-446-5844
Europe: 31-(0) 40 2675 150 International:
425-446-5500
Where to Buy:
www.pomonaelectronics.com
All dimensions are in inches. Tolerances (except noted): .xx = ±.02″ (,51 mm),
.xxx = ± .005″ (,127 mm). All specifications are to the latest revisions.
Specifications are subject to change without notice. Registered trademarks are
the property of their respective companies.
Copyright © 2012 D1094270 Rev. 100
Downloaded from Arrow.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>