LiftMaster 811LMX Programmable DIP Switch Remote Controls Instruction Manual
- June 6, 2024
- LiftMaster
Table of Contents
PROGRAMMABLE DIP SWITCH
REMOTE CONTROLS
Models 811LMX and 813LMX
Introduction
The 811LMX and 813LMX are programmable DIP switch remote controls for use with
LiftMaster commercial products using Security+ 2.0® Encrypted DIP, as well as
older 315 MHz DIP and 390 MHz DIP devices. The remote control default setting
is Security+ 2.0®.
The 813LMX model is designed for OPEN/ CLOSE/STOP functionality.
The images throughout this manual are for reference only and your product
may look different.
WARNING
To prevent possible serious injury or death from a moving gate or garage door:
- ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters.
- Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
- ALWAYS keep the gate or garage door in sight until completely closed. Never permit anyone to cross the path of moving gate or door.
WARNING: This product can expose you to chemicals including lead, which
is known to the State of California to cause cancer or birth defects or other
reproductive harm. For more information go to
www.P65Warnings.ca.gov.
Programming
Step 1: Set the DIP Switches
- Slide the cover open to access the DIP switches.
- Use a pen or screwdriver to slide the DIP switches to any position you want (ON or OFF).
Step 2: Select the Security Type
NOTE: If the device you use with this remote is Security+ 2.0®
Encyrpted DIP, skip this step and go to Step 3: Program the Remote to a
Device. Follow these steps to select 315 MHz DIP, 390
MHz DIP or reset the remote to Security+ 2.0® Encrypted DIP from a different
setting.
- Locate and press the Program Button. The LED glows steady Yellow.
- Press any remote control button the number of times that corresponds to the security type for your device.
| # OF PRESSES | DEVICE SECURITY TYPE |
|---|---|
| 1 | Security+ 2.0 |
| 2 | 315 MHz DIP |
| 3 | 390 MHz DIP |
3. Press and hold the Program Button until the LED on the front of the remote
turns off.
Step 3: Program the Remote to a Device
See your LiftMaster device’s manual for programming.
- Press and release the LEARN button on your device.
- Within 30 seconds press and hold the button on the remote control that you wish to program to the device.
- Test by pressing the remote button you just programmed. The operator or gate activates. Additional buttons on the 813LMX can be programmed to operate other devices of the same security type.
Open, Close, Stop
The 813LMX can be programmed for OPEN/CLOSE/STOP functionality. Refer to your
device manual for instructions.
The Remote Control Battery
The lithium battery should produce power for up to 3 years. To replace the
battery:
Remote 811LMX or (IFT#: _____)
Operation of this equipment is subject to the following two conditions:
(1) This equipment may not cause harmful interference, including that which
may cause undesired operation.
WARNING:
To prevent possible SERIOUS INJURY or DEATH:
- NEVER allow small children near batteries.
- If the battery is swallowed, immediately notify the doctor.
To reduce risk of fire, explosion, or chemical burn:
- Replace ONLY with 3V CR2032 coin batteries.
- DO NOT recharge, disassemble, heat above 212°F (100°C), or incinerate.
NOTICE: To comply with FCC and/or Industry Canada (IC) rules, adjustment
or modifications of this transceiver are prohibited.
THERE ARE NO USER-SERVICEABLE PARTS?
This device complies with Part 15 of the FCC rules and IC RSS-210.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Replacement Parts
Visor Clip . . . . . . . . . . . . . . . . . . . . . . K029B0137
3V CR2032 lithium Battery . . . . . . .. . . . . . . . . . . . K010A0020
FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER:
1-800-528-2806
LiftMaster.com
© 2021 LiftMaster
All Rights Reserved
114-5565-000
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>