AJL 5 Panel Bouncy Castle Instruction Manual
- October 30, 2023
- AJL
Table of Contents
Instructions for putting away a 5-panel bouncy castle
Instruction Manual
5 Panel Bouncy Castle
Disconnect the blower and undo all of the tubes and/or zips. As the inflatable falls down, push in the side and rear walls.
Deflator
If you have the AJL deflator, attach this to the side of your deflator
compatible blower and then slot the deflator into the zip of your inflatable. Do
not put it onto the blower tube as this will cause a vacuum and will not work
effectively. See the pictures below.
Once inside the bouncy castle via the zip. Turn the blower back onto to begin
deflating.
If your inflatable
does not have a zip, then you can use the blower tube by squashing it right up
to side of the inflatable, to prevent the blower tube from vacuuming onto
itself. See the pictures below.
Pull the rear
wall and towers onto the inflatable so that they lie over the side walls. Make
sure everything is lying flat. It should now look like the photograph below.
Fold over the
right hand side by 2 panels, followed by the left hand side by 1 panel and
finally fold it in half from the right hand side. Tread out as much air as
possible.
Between all of
these folds, walk down the inflatable from front to back, squeezing out the
air.
With one person treading down any lumps in the inflatable, 2 others roll it up.
Apply some downwards pressure as you roll to keep it tight.
When you reach
the end, insert the rope/strap underneath, fold in the tubes and anchor-points
and make the final turn. Keep the weight on the end to stop it unfolding as you
tie the rope.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>