hansgrohe 73817800 Metris Select Kitchen Mixer Instruction Manual

hansgrohe 73817800 Metris Select Kitchen Mixer

Safety Notes

Gloves should be worn during installation to prevent crushing and cutting injuries.

The hot and cold supplies must be of equal pressures.

Installation Instructions

• Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the applicable standards.
• The plumbing codes applicable in the respective countries must be observed.
• During initial start-up and after servicing, air in the fittings can cause noise. After switching the jet on and off about 15 times, the noise will stop.

Technical Data

Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 – 0,5 MPa 
Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 70°C
Recommended hot water temp.: 65°C
Thermal disinfection: max. 70°C / 4 min

The product is exclusively designed for drinking water!

Symbol description

• Do not use silicone containing acetic acid!
  
  

• Adjustment
  

• Maintenance
  

• Dimensions
  

• Flow diagram
  

• Spare parts
  

• Special accessories (order as an extra)

• Cleaning

• Operation

Troubleshooting

• connection hoses not completely screwed into basic body
• O-ring at the connection hose defective.

|

• Tighten connection hoses by hand
• Exchange O-ring

Hot water temperature too low|

• Hot water limiter incorrectly set

|

• Set hot water limiter

Low flow with Select valve after valve replacement|

• Improper Select valve installed

|

• Replace Select valve (#98463000)

Select button stiff|

• Select button soiled

|

• Clean Select button and grease #98201000 O ring (see page 40)

Operation

• Hansgrohe recommends not to use as drinking water the first half liter of water drawn in the morning or after a prolonged period of non-use.

• Minor leaking may occur briefly at the spout when opening the fitting via the lever.

• Use the lever to open the tap and set the desired temperature. The water flow can be paused by pressing the Select button on the face side of the spout. When the tap is not used for a longer period of time, f.e. when retiring at night or leaving the house, it must be closed completely by means of the lever.

• open
  
  

• close
  
  

• **hot

**

• **cold

**

Assembly

Special accessories

extension #43333000

Adjustment

To adjust the hot water limiter. Using a hot water limiter in combination with a continuous flow water heater is not recommended.

Maintenance

Cleaning

Cleaning recommendation / Warranty / Contact

http://www.hansgrohe.com/cleaning-recommendation

http://www.hansgrohe.com/cleaning-recommendation

http://www.hansgrohe.com/cleaning-recommendation

http://www.hansgrohe.com/cleaning-recommendation

Dimensions

Metris Select M71 240 1jet sBox
73802XXX

Metris Select M71 240 2jet sBox
73817XXX

Metris Select M71 240 2jet sBox
72834000

Flow diagram

Metris Select M71 240 1jet sBox
73802XXX

Metris Select M71 240 2jet sBox
73817XXX / 72834000

Spare parts

 Test certificate

|

P-IX

|

DVGW

|

SINTEF

|

NF

| |

ETA

|

GODKENDT TIL DRIKKEWAND

---|---|---|---|---|---|---|---
73802XXX| P-IX 29603/IA| | | | X| |
73817XXX| P-IX 16917/IOO| | | | X| |
72834000| | | | | | |

Other models

Metris Select M71 240 1jet sBox
73802XXX

Customer Support

Hansgrohe · Auestraße 5 – 9 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440
E-Mail: info@hansgrohe.com · Internet: www.hansgrohe.com

9/2019
9.05935.04

References

• Taps for bathrooms, showers and kitchens | hansgrohe INT
• Taps for bathrooms, showers and kitchens | hansgrohe INT
• hansgrohe.com/cleaning-recommendation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>