hansgrohe 34113000 AXOR Washbasin Mixers Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
hansgrohe 34113000 AXOR Washbasin Mixers
Product Information
The product is a shower system that can be used for bathing, hygienic and body cleansing purposes. The shower system is a single lever mixer with Warmwasserbegrenzung which can be adjusted on page 32. The product has a maximum operating pressure of 1 MPa and a recommended operating pressure of 1.6 MPa. The product also has a flow limiter and can be used with continuous- flow water heaters.
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting
injuries. The hot and cold supplies must be of equal pressure.
Technical Data
The product has a maximum operating pressure of 1 MPa and a recommended
operating pressure of 1.6 MPa. The hot water temperature should be at the
recommended hot water temperature.
Usage Instructions
The shower system may only be used for bathing, hygienic and body cleansing purposes. The hot and cold supplies must be of equal pressure. To operate the product, please see page 34 for detailed instructions. Do not use silicone- containing acetic acid for cleaning.
Assembly Instructions
To assemble the product, please see page 31 for detailed instructions. An
installation kit is not included in the package and should be ordered as an
extra.
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The shower system may only be used for bathing, hygienic, and body cleansing purposes.
- The hot and cold supplies must be of equal pressure.
Installation Instructions
- The fitting must be installed, flushed, and tested after the valid norms.
- If the instantaneous water heater causes problems or if you wish to increase the water flow, the EcoSmart® (flow limiter) located behind the aerator can be removed.
- Hansgrohe mixers can be used together with hydraulically and thermally controlled continuous flow heaters if the flow pressure is at least 0,15 MPa.
Method 1
Method 2
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter)
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
- Hot water temperature: max. 80°C
- Recommended hot water temp.: 65°C
Assembly
Symbol Description
To adjust the hot water limiter on single lever mixers. No adjustment is
necessary when using a continuous-flow water heater.
- Do not use silicone-containing acetic acid!
Dimensions
Flow diagram
- with EcoSmart®
- without EcoSmart®
Spare parts
Special accessories
Installation kit order as an extra
Operation
close
open
Cleaning
Test certificate
Hansgrohe
Postfach 1145 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax
+49 (0) 7836/511440
E-Mail: info@hansgrohe.com. Internet:
www.hansgrohe.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>