hansgrohe 34113000 CITTERIO M Single Lever Basin Mixer Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
- hansgrohe 34113000 CITTERIO M Single Lever Basin Mixer
- Product Usage Instructions
- Safety Notes
- Installation Instructions
- Technical Data
- Dimensions
- Flow diagram
- Spare parts
- Operation
- Cleaning
- Test certificate
- Assembly
- I nstruction
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
hansgrohe 34113000 CITTERIO M Single Lever Basin Mixer
Product Information
The product is a shower system with a single lever mixer and a hot water limiter. It is designed to be used for bathing, hygienic and body cleansing purposes. The shower system requires equal pressures for the hot and cold water supplies. It has a maximum operating pressure of 1 MPa and a recommended operating pressure of 1.6 MPa. The hot water temperature and recommended temperature are not specified. The product comes with spare parts and a cleaning brochure. An installation kit is not included in the package and needs to be ordered separately.
Product Usage Instructions
Before installation, wear protective gloves to prevent crushing and cutting
injuries. To use the shower system, turn on the water supply and adjust the
temperature using the single lever mixer. To adjust the hot water limiter,
refer to page 32 in the user manual.
The hot water limiter does not need to be adjusted when using a continuous
flow water heater.
Do not use silicone containing acetic acid. This can damage the product. The product can only be used for bathing, hygienic and body cleansing purposes.
For installation, follow the instructions provided on page 31 of the user manual. The shower system requires equal pressures for the hot and cold water supplies. The maximum operating pressure is 1 MPa and the recommended operating pressure is 1.6 MPa. The user manual provides a flow diagram on page 33 and dimensions on the same page. Spare parts are available on page 36 of the user manual.
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The shower system may only be used for bathing, hygienic and body cleansing purposes.
- The hot and cold supplies must be of equal pressures.
Installation Instructions
- The fitting must be installed, flushed and tested after the valid norms.
- If the instantaneous water heater causes problems or if you wish to increase the water flow, the EcoSmart® (flow limiter) located behind the aerator can be removed.
- Hansgrohe mixers can be used together with hydrau-lically and thermically controlled continuous flow heaters if the flow pressure is at least 0,15 MPa.
Technical Data
This mixer series-produced with EcoSmart® (flow limiter)
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0,1 – 0,5 MPa
- Test pressure: 1,6 MPa (1 MPa = 10 bar = 147 PSI)
- Hot water temperature: max. 80°C
- Recommended hot water temp.: 65°C
Symbol description
To adjust the hot water limiter on single lever mixers, please see page 32. No adjustment is necessary when using a continuous-flow water heater.
Do not use silicone containing acetic acid!
Dimensions
Flow diagram
- with EcoSmart®
- without EcoSmart®
Spare parts
Special accessories
Installation kit order as an extra
Operation
close
Cleaning
enclosed brochure
Test certificate
Assembly
I nstruction
Hansgrohe · Postfach 1145 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282
· Telefax +49 (0) 7836/511440
E-Mail: [email protected] · Internet:
www.hansgrohe.com