6-LIGHT CHANDELIER 38684-HBCB 6 Light Chandelier Instruction Manual

**6-LIGHT CHANDELIER 38684-HBCB 6 Light Chandelier Instruction Manual

**

Safety Information

• Read all instructions before assembling and installing.
• Consult a qualified electrician for installation of this Mixture.
• If you have any non-electrical questions about this Mixture, please contact our Customer Service Team at 1-833-695-2045 or visit WWW.HOMEDEPOT.CA / HOMEDEPOT.COM / GLUCKSTEINELEMENTS.COM.

CAUTION: Before starting installation of this Mixture or removal of a previous Mixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.

IMPORTANT:   Inspect the wire insulation for any cuts, abrasions, or exposed copper that have occurred during shipping. If there is a defect in the wire, do not continue the assembly process. Please call our Customer Service Team at 1-833-695-2045

IMPORTANT: Do not install this lighting system in damp or wet locations

Warranty

LIMITED WARRANTY

WHAT IS COVERED

The manufacturer warrants this lighting Mixture to be free from defects in materials and workmanship for a period of Ffive (5) years from date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair Rrreplacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modification, alteration, neglect, or mishandling.

WHAT IS NOT COVERED

This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, faulty installation, or any other failure not relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty contained herein. The manufacturer specififically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including but not limited to any labor/expense costs involved in the replacement or repair of said product.

Pre-Installation

PLANNING INSTALLATION

Read all instructions before assembly and installation. To avoid damaging this product, assemble it on a soft, non-abrasive surface, such as carpet or cardboard. Inspect each part for defects that may have occurred during shipping. Keep your receipt and these instructions for proof of purchase.

TOOLS REQUIRED

• Safety goggles

• Phillips screwdriver

• Flathead screwdriver

• Wire strippers

• Wire cutters

• Ladder

HARDWARE INCLUDED

NOTE: Hardware not shown to actual size.

Pre-Installation (continued)

PACKAGE CONTENTS

Installation

Installing the center rod and the canopy

• Pass the wires of the fixture body (A) through the center rod (B) (C) (D), and then install the center rod (B) (C) (D) to the fixture body (A).
• Install the canopy (E) to the center rod (B) (C) (D)

Installing the universal crossbar

  WARNING: Turn off power at the main fuse box.

• Install the universal crossbar (EE) to the junction box (not included) with the supplied junction box screws (BB)

Making the electrical connections

NOTE: Always use the wire nuts (AA) to connect wires and push all excess wires and connections back into the junction box (not included).

• Fasten the hanging buckle of the canopy (E) to the universal crossbar (EE)
• Wrap the ground wire from the Mixture around the ground screw (CC) on the universal crossbar (EE), and then connect the ground wire (two) from the fixture to the ground wire from the junction box.
• Connect the black wire of the power supply to the black wire of the Mixture and connect the white wire of the power supply to the white wire of the Mixture .

Installing the Mixture body

• Attach the Mixture body (A) to the universal crossbar (EE) and secure it with the supplied canopy screws (DD).

Installing the glass shade and the bulbs

• Install the glass shade (F) to each socket of the Mixture body (A) and tighten with the socket ring (FF).
• Install 60W MAX B10 bulbs (not included) to each socket of the Mixture body (A)

Care and Cleaning

• Clean the light Mixture carefully with a soft, dry cloth. Do not use any cleaners with chemicals, solvents, or harsh abrasives.

Troubleshooting

ON position
The fuse blows or the circuit breaker trips when the light is turned on.| There are too many items on one circuit.|

• Unplug the other items on the circuit.
• Please contact 1-833-695-2045 for further assistance. Contact a quali­ed electrician or call the Customer Service Team at 1-833-695-2045.

Costumer Support

Questions, problems, missing parts? Before returning to the store,
call Gluckstein Elements Customer Service
8 a.m. – 7 p.m., EST, Monday-Friday, 9 a.m. – 6 p.m., EST, Saturday
1-833-695-2045
HOMEDEPOT.CA
HOMEDEPOT.COM
GLUCKSTEINELEMENTS.COM
Retain this manual for future use

References

• Home Furnishings + Decor | GlucksteinHome | GlucksteinElements
• Home Improvement, Home Renovation, Tools, & Hardware - Homedepot.ca
• The Home Depot
• Home Improvement, Home Renovation, Tools, & Hardware - Homedepot.ca

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>