IKEA STRÅLA 5-arm LED Candelabra Pine Instruction Manual
- October 30, 2023
- Ikea
Table of Contents
IKEA STRÅLA 5-arm LED Candelabra Pine Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Do not use seasonal products outdoors unless marked suitable for indoor and
outdoor use. When products are used in outdoor applications, connect the
product to a Ground Fault Circuit Interrupting (GFCI) outlet. If one is not
provided, contact a qualified electrician for proper installation.
This seasonal use product is not intended for permanent installation or use.
Do not mount or place near gas or electric heaters, fireplaces, candles or
other similar sources of heat.
Do not secure the wiring of the product with staples or nails, or place on
sharp hooks or nails.
Do not let lamps rest on the supply cord or on any wire.
Unplug the product when leaving the house, when retiring for the night, or if
left unattended.
This is an electric product – not a toy! To avoid risk of fire, burns,
personal injury and electric shock it should not be played with or placed
where small children can reach it.
Do not use this product for other than its intended use.
Do not hang ornaments or other objects from cord, wire, or light string.
Do not close doors or windows on the product or extension cords as this may
damage the wire insulation.
Do not cover the product with cloth, paper or any material not part of the
product when in use.
Read and follow all instructions that are on the product or provided with the
product.
USE AND CARE INSTRUCTIONS
Before using or reusing, inspect product carefully.
Discard any products that have cut, damaged, or frayed wire insulation or
cords, cracks in the lampholders or enclosures, loose connections, or exposed
copper wire.
When storing the product, carefully remove the product from wherever it is
placed, including trees, branches, or bushes, to avoid any undue strain or
stress on the product conductors, connections, and wires. When not in use,
store neatly in a cool, dry location protected from sunlight.
This device complies with part 15 of the FCC Rules.
Operation is subjected to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Risk of fire.
How to replace the lamp:
Grasp plug and remove from the receptacle or other outlet device. Do not
unplug by pulling on cord. Unscrew lamp counter clock-wise.
CAUTION
Risk of fire.
This product does not contain lamp shunts in order to allow the product to
operate if one lamp burns out. Do not replace lamps with other than the spare
lamps provided with this product.
WARNING
Deviation from the assembly instructions may result in a risk of fire or
electric shock.
SAVE THESE INSTRUCTIONS
**Tools
**
Instructions
