Aqua EZ Jet Vac Pool Vacuum Instruction Manual
- October 30, 2023
- Aqua EZ
Table of Contents
Jet Vac Pool Vacuum
Instruction Manual
ASSEMBLY INSTRUCTIONS
A. Firmly insert vacuum head #8 into the main body #10. Be sure that
connecting handle #6 is positioned directly underneath the quick connector #3.
Then place handle pin #9 in its proper hole, where connecting handle and
vacuum head meet.
B. Place fine mesh bag #7 over the main body rim. Tighten bag by using the
cord-tightening pin #5.
C. Screw pole sections #1 together to preferred height. Then screw pole into
the connecting handle #6.
D. Attach female quick connect #4 to garden hose #2. Be sure that a washer is
between the threads and garden hose to prevent leaking. (Garden Hose Sold
Separately)
E. Firmly press to connect the male quick connect fitting #4 into the female
quick connect fitting #3.
OPERATING INSTRUCTIONS
A. Loop garden hose around vac pole twice to keep hose and pole together
during vacuuming. This will prevent hose from stirring up dirt from floor of
pool.
B. Connect garden hose using quick connect fitting into body of Jet Vac.
C. Lower Jet Vac into pool.
D. Turn garden hose on full pressure.
E.
Vacuum pool allowing debris to collect into fine mesh bag.
F. When vacuuming is complete, turn garden hose off. Remove fine mesh bag and
empty contents into trash.
ADDING A TELESCOPIC POLE
Replace connecting handle with a replacement vacuum handle. Slide telescopic
pole over connecting handle and snap into place.
Note: Telescopic pole and replacement vacuum handle sold separately.
6100 Wheaton Dr. Atlanta, Georgia 30336
Tel (404) 696-2707
Fax (404) 460-1250
Toll Free (877) 852-4264
http://www.aquaez.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>