IKEA HAMNSKÄR Bath Faucet with Strainer Instruction Manual
- October 30, 2023
- Ikea
Table of Contents
IKEA HAMNSKÄR Bath Faucet with Strainer
Product Information
The product is a mixer tap that should be installed in compliance with local construction and plumbing regulations. The installation process should be performed by a professional to ensure safety and proper functioning of the product. The main shut-off valve must be switched off before changing the mixer tap to prevent any potential damage. It is important not to tighten the hoses/pipes and washers too hard as this may cause damage to the product.
The product is compatible with a range of pressure levels, including 1-5 bar (14.5-72.5 psi) and 0.5-10 bar (7.2-145 psi).
Product Usage Instructions
- Ensure that the installation process is performed in compliance with local construction and plumbing regulations. If in doubt, contact a professional.
- Switch off the main shut-off valve before changing the mixer tap.
- When changing the mixer tap, do not tighten too hard to avoid damaging the hoses/pipes and washers.
It is important to note that the product is compatible with a range of pressure levels. Ensure that the pressure level in your area is within the compatible range before using the product.
Installation must be performed in compliance with current local construction
and plumbing regulations. If in doubt, contact a professional.
Switch off main shut-off valve before changing mixer tap.
IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and
washers.
TOOLS REQUIRED
IF YOU HAVE ANY QUERIES, CONTACT US AT:
BOX INCLUDE
ASSEMBLY
Before use: Unscrew the Aerator/Flow Guide and allow the water to run freely for a few minutes. Then screw the Aerator/Flow Guide back in place. Ensure that it is tight to prevent removal by hand.
Check at regular intervals to make sure that the installation is not leaking.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>